BlendMount BRD-2006 Radenso Pro Mount Instruction Manual
- June 3, 2024
- BLENDMOUNT
Table of Contents
BlendMount BRD-2006 Radenso Pro Mount Instruction
INSTALLATION INSTRUCTIONS FOR THE C6 CORVETTE REAR VIEW MIRROR
Install your radar detector (RD) onto the mount before attaching to the rear
view mirror so you can observe how the Spring Clip functions. Squeeze the
Spring Clip Release Tab and the back side of the mount together. Push the RD
Release button and slide the RD onto the Spring Clip until the RD hits the
bottom of the Spring Clip Release Tab. Then release both the Tab and the
Button. Now slide the RD just slightly toward you until you hear it lock into
position
Observe the illustration above which identifies the components of the mount.
Remove the Spring Clip by removing both Pinch Plate Screws
IMPORTANT
Observe the two Clamp Screws that are accessible through the slots of the Rotating Adjustment Plate. Before installing the mount, insert the supplied allen wrench into the heads of the Clamp Screws to make sure they are accessible.
This photo illustrates how the Hook fits into the recessed area behind the mirror. This is just a reference photo as you will not be able to see this during installation.
Place the Windshield Pad onto the Silicone Pad. Position the mount as shown above. Compress the Silicone Pad into the Windshield Pad as you slide upwards into the recessed area behind the mirror. You will hear the Hook snap into place when it is positioned correctly as shown in fig. 6.
Tighten the two Clamp Screws (identified in fig. 3), alternating from one to
the other every two or three revolutions. You will notice a little resistance
once the Rubber Pad starts compressing against the bottom of the mirror. Make
sure that both Clamp Screws are tight. Reattach the Spring Clip the Pinch
Plate.
Install the RD onto the mount making sure it locks onto the Spring Clip. You
should hear it lock into position. Make the necessary adjustments as shown. We
recommend adjusting the RD so it is as close to the bottom of the mirror as
possible. There may not be enough room for your finger to fit between the RD
and the mirror, however the spring clip allows you to move the RD downward
with one finger while press
We recommend installing the 3/4″ diameter Support Pad between the mirror and the RD for additional stability. There are three different thicknesses included depending on the gap between the RD and the mirror after all adjustments are made. Use the supplied alcohol pad to clean the top of the RD before installing Support Pad
CAUTION
DO NOT use this mount if it interferes with the adjustability or the
operation of your rear view mirror in any way.
DO NOT use this mount if the radar detector creates an unsafe viewing
obstruction.
DO NOT ATTEMPT TO MODIFY THIS PRODUCT. Consult the manufacturer for
assistance.
All BlendMount products are accompanied with detailed installation
instructions and adjustment tips. You are encouraged to contact customerser
rice@blendmount.
com or call J28 Design at
1-707-664-8234 for further assistance.
Your feedback is very important to us. Please email any questions or comments
you have to customerservice@blendmount.com
Blend Mount – US PATENT# D625,580 S and other
patents pending