Z-Wave HS2SK-Z Smart Metering Plug User Guide

Table of Contents

Product

Product is S2 Unauthenticated devices.
This device is a security enable Z‐Wave Plus product that is able to use encrypted Z‐Wave Plus messages to communicate to other security enable Z‐Wave Plus products.
Note: A “Security Enable Z‐Wave Controller” must be used in order to fully utilize this function.

Device ADD for Inclusion
- Click [Add] icon in Z‐Wave Controller.
- Press the SW_Button 3 times within 1.5s, Blue LED is Blinking 3 times within 1 second.
- If add Process is successful, Blue LED will turn off.
Device Remove for Exclusion
- Click [Remove] icon in Z‐Wave Controller.
- Press the SW_Button 3 times within 1.5s
- If remove Process is successful, blue LED is Blinking 6 times, then turn off.
Device normal mode
Press button to power plug on and Blue LED turns on, press button again to power plug off and blue LED turns off. Plug reports power consumption(Unit: KWH) every 60s seconds when plug is outputting power. A power(W) change of 2 watts is reported immediately.
Device Factory Reset
- Long press SW_Button at least 10 seconds in HS2SK‐Z.
- Device Reset Locally notification is Transmitted.
- Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Association & Association Group Information
- Lifeline between controller and HS2SK‐Z
- Maximum supported node is 5
- Association Group description
  Association group 1: Lifeline association group
  Include command classes: Switch Binary report, Meter Report and Device Reset Locally notification.
Binary Switch Report and Meter Report
- Press SW_Button, Switch Report is transmitted
  Switch TYPE

Switch Type	Value	Status
Binary Switch Report	0x00	OFF
0xFF	ON

Meter Type

Meter Type	Assortment	Status
**** Electric meter	KWH	0X00
WATT	0X02

Basic Command Class description
- Support command class version is 2 .
- Gateway can set device turn on and shutdown
- Press SW_Button, Switch Report is transmitted
- Binary Switch Report is 0xff to turn on
- Binary Switch Report is set to 0x00 to shutdown
  Basic Type| Value| Status
  ---|---|---
  Basic Set| 0x00| OFF
  0xFF| ON
Devices from multiple manufacturers in one network
- This product can be included and operated in any Z‐Wave network with other Z‐Wave certified devices from other manufacturers and/or other applicants. All non‐battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
Z‐Wave Specifications
- Device Type : On/Off Power Switch
- Role Type : AOS (Always on slave)
- Command Class Support/Control
- Z‐Wave plus InfoVersion 2
- Switch Binary Version 1
- Association Version 2
- Multi Channel Association Version 3
- Association Group Info Version 1
- Transport Service Version 2
- Version Version 3
- Manufacturer Specific Version 2
- Device Reset Locally Version 1
- Power level Version 1
- Security 2 Version 1
- Supervision Version 1
- Meter Version 4
- The below listed Command Class are all Supported the Security S2
- Switch Binary Version 1
- Association Version 2
- Multi Channel Association Version 3
- Association Group Info Version 1
- Version Version 3
- Manufacturer Specific Version 2
- Device Reset Locally Version 1
- Power level Version 1
- Meter Version