iTECH WEARABLES iTECH AMP Pro Wireless Earbuds Instruction Manual
- June 3, 2024
- iTECH WEARABLES
Table of Contents
iTECH AMP Pro
WIRELESS EARBUDS
USER MANUAL
iTECH AMP Pro Wireless Earbuds
iTECH® AMP Pro Earbuds
A. Touchpad
B. Earbuds
C. Charging Case with USB-C charging port
D. Wireless Charging Area (rear of case)
OPERATING INSTRUCTIONS
Fully charge your device before using.
POWER ON Remove the earbuds from the charging case to power on each
earbud. When both earbuds are on, they will automatically pair to each other
within a couple of seconds.
POWER OFF Insert the earbuds into the charging case to shut down. You can
also long-press the touchpad for 5 seconds to power them off. The light will
flash red to indicate that they are powering off.
BLUETOOTH PAIRING The earbuds will pair to each other (left & right)
automatically. When paired to each other, the left earbud will flash blue &
the right earbud will continue to flash red & blue to indicate that the
earbuds are ready to pair with a device.
Make sure your device’s Bluetooth settings are turned on. The earbuds will
appear as iTech AMP Pro in your device list.
Select iTech AMP Pro to pair with your device.
USING YOUR EARBUDS
Control the earbuds by using the earbud touchpads:
- Tap: play/pause, answer/hang up
- Double tap (L): Restart Track or go to Previous song
- Double tap (R): Next song
- Long press for 2 seconds: Reject call
- Long press for 5 seconds: Power on/off
LED LIGHT INDICATOR
- Device Connected: no LED light (light off)
- Pairing Mode: Flashing RED AND BLUE
CHARGING
Working time: 5 hours
*Charging time:* ~1.5 hours (via USB-C cable)
wireless charging times vary based on charger type
REGULATORY NOTICE
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be located or operated in conjunction with any other antenna or transmitter.
DO NOT RETURN PRODUCT TO THE
STORE FOR SUPPORT
FOR TECHNICAL ASSISTANCE, WARRANTY
AND CUSTOMER SERVICE, EMAIL:
support@itechwearables.com
OR VISIT US AT:
support.itechwearables.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>