WOLF ICBSO3050TE E Series Ovens User Guide
- June 3, 2024
- Wolf
Table of Contents
WOLF ICBSO3050TE E Series Ovens User Guide
Introduction
E Series Built-In Ovens
The Wolf E Series Convection Oven has two fans and four heating elements. Ten
cooking modes allow you to select the one precisely suited to the dish you’re
preparing. The oven is self-cleaning. E Series Ovens are crafted of stainless
steel. The handles match the rest of the Wolf cooking appliance offering,
providing a more cohesive look.
E Series Ovens can be installed in a standard or flush inset application
Features and specifications are subject to change at any time without notice.
Throughout this guide, dimensions may vary by ± 3 mm.
E SERIES OVENS
TRANSITIONAL
ICBSO24TE/S/TH
ICBSO3050TE/S/TH
PROFESSIONAL
ICBSO3050PE/S/PH
60 cm E Series Oven
MODEL ICBSO24TE/S/TH TRANSITIONAL SINGLE OVEN
E Series Built-In Ovens
TRANSITIONAL
PROFESSIONAL
Planning Information
The E series oven can be installed in a standard or flush inset application.
If a cooktop is installed above an oven, a minimum of 6 mm is required between
the units. The location of the electrical supply within the oven opening may
require additional cabinet depth.
Finish the edges of the opening. They may be visible when the door is open.
For standard installations, the face trim overlaps stiles and rails. Refer to
the chart below.
For flush inset installations, a minimum 3 mm reveal is required on all sides.
To ensure consistent reveals, each
corner of the opening must be exactly 90°.
INSTALLATION REQUIREMENTS
- BASE SUPPORT: MIN
- 60 cm Oven: 68 kg
- 76 cm Oven: 115 kg
TRIM OVERLAP | 60 cm OVEN | 76 cm OVEN |
---|---|---|
Top | 6 mm | 25 mm |
Bottom | 0 mm | 0 mm |
Sides | 17 mm | 18 mm |
ELECTRICAL REQUIREMENTS—60 cm OVEN
Installation must comply with all applicable electrical codes and be properly
grounded (earthed).
Locate the electrical supply as shown in the illustrations on the following
pages. A separate circuit servicing only this appliance is required. Refer to
the illustration below for minimum power cord plug clearance.
ELECTRICAL REQUIREMENTS—60 cm OVEN
- Electrical Supply: 220–240 V AC, 50 Hz
- Service: 3400 W
- Receptacle: grounding-type (earthed)
- Power Cord: 1.8 m
ELECTRICAL REQUIREMENTS—76 cm OVEN
Installation must comply with all applicable electrical codes and be properly
grounded (earthed).
Locate the electrical supply flush with the back wall and within the shaded
area shown in the illustrations on the following pages. For ease of
installation, the electrical supply for the oven can be placed in an adjacent
cabinet within reach of the conduit.
Performance may be compromised if the electrical supply is less than 240
volts.
The oven is supplied with a single phase and 3-phase convertible power inlet
box. The wiring diagram covering the control circuit is provided with the oven
ELECTRICAL REQUIREMENTS—76 cm OVEN
REQUIRED POWER SUPPLY
- Single Phase: 220–240 V AC, 50/60 Hz
- 3-phase: 380–415 V AC, 50 Hz
- Maximum Connected Load: 4.8 kW
- Total Amps: 20
- Maximum Amps per Line: 15
STANDARD INSTALLATION
60 cm E Series Oven
Does not include additional depth for the electrical connection.
- OPENING HEIGHT: H
- ICBSO24TE/S/TH: 591 mm
FLUSH INSET INSTALLATION
60 cm E Series Oven
-
Will be visible and should be finished to match cabinetry.
-
Dimension provides minimum reveals.
-
Does not include additional depth for the electrical connection
-
FLUSH INSET HEIGHT: H
-
ICBSO24TE/S/TH: 603 mm
STANDARD INSTALLATION
76 cm E Series Oven
NOTE: Location of electrical supply within opening may require additional
cabinet depth.
FLUSH INSET INSTALLATION
76 cm E Series Oven
Shaded areas will be visible and should be finished to match cabinetry.
Dimension provides minimum reveals.
NOTE: Location of electrical supply within opening may require additional
cabinet depth.
Warranty
Wolf Appliance International Limited Warranty
FOR RESIDENTIAL USE
These Warranty Terms and Conditions (‘Warranty’) constitute your agreement
with Sub-Zero Group Australia Pty Ltd (ACN 610 807 899) (‘Wolf’) and will
apply to your service order. The benefits given by this Warranty are in
addition to all consumer guarantees and other rights and remedies prescribed
by the Australian Consumer Law and any other applicable laws.
Our products come with guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a replacement or refund for a major failure
and compensation for any other reasonably foreseeable loss or damage. You are
also entitled to have the goods repaired or replaced if the goods fail to be
of acceptable quality and the failure does not amount to a major failure.
In addition to your rights and remedies under the Australian Consumer Law,
Wolf provides customers with a Warranty where, if any part of a Wolf product
is found upon inspection by an authorized Wolf representative or an associated
licensed technician supplied by either Wolf or a relevant approved supplier
(including a Wolf factory certified service) (‘Service Representative’) to be
defective in materials or workmanship, Wolf will repair and replace the part
as follows:
FULL TWO YEAR WARRANTY *
(**Outdoor product full one year warranty)
For two years from the date of original installation, this Wolf Appliance
product warranty covers all parts and labour to repair or replace, under
normal residential use, any part of the product that proves to be defective in
materials or workmanship. All service provided by Wolf Appliance under the
above warranty must be performed by Wolf factory certified service, unless
otherwise specified by Wolf Appliance, Inc. Where the Service Representative
is unable to identify any fault in the product, Wolf may require the consumer
to provide proof that the product is defective. For the avoidance of doubt,
defective products or parts become Wolf’s property. Service will be provided
during normal business hours.
LIMITED FIVE YEAR WARRANTY
For five years from the date of original installation, Wolf Appliance will
repair or replace the following parts that prove to be defective in materials
or workmanship: gas burners (excludes appearance), electric heating elements,
blower motors (ventilation hoods), electronic control boards, magnetron tubes
and induction generators. If the owner uses Wolf factory certified service,
the service provider will repair or replace the above listed parts at no cost
with the owner paying for all other costs, including labour. If the owner uses
non-certified service, the owner must contact Sub-Zero Group Australia, (using
the information below) to receive repaired or replacement parts. Wolf
Appliance will not reimburse the owner for parts purchased from non-certified
service or other sources.
TERMS APPLICABLE TO EACH WARRANTY
The warranty applies only to products installed for normal residential use.
This warranty does not cover any parts or labour to correct any defect caused
by negligence, accident or improper use, maintenance, installation, service or
repair.
CLAIM PROCEDURE
In order to claim the Warranty, you must cease using the product when a fault
arises, contact Sub-Zero or authourised Sub-Zero dealer where the product was
purchased to report the issue and follow Sub-Zero’s directions regarding what
to do next. SubZero’s general contact details are as follows:
Sub-Zero Group Australia
11-19 Bank Place
Melbourne VIC 3000
Phone: 03 9600 2218 email: serviceAU@subzero.com
EXCLUSIONS
Except to the extent required by law, all consumer guarantees,
representations, warranties, terms and conditions in relation to the products
(whether implied or otherwise) are hereby excluded to the maximum extent
permitted by law.
To the fullest extent permitted by law, Wolf excludes all liability for damage
or injury to any person, damage to any property and any indirect consequential
or other loss or damage.
Warranty
*Stainless steel (doors, panels, handles, product frames and interior surfaces) are covered by a limited 60-day parts and labor warranty for cosmetic defects.
** Full one year warranty applies to outdoor product. Product must be approved
for outdoor use, designated by model and serial number
Customers Support
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>