WOLF ICBSO2450TE-S-T Transitional Single Oven User Guide

WOLF ICBSO2450TE-S-T Transitional Single Oven

Product Information

Specifications:

• Model: E Series Ovens
• Features: Two fans, four heating elements, self-cleaning, stainless steel construction
• Cooking Modes: 10
• Installation: Standard or flush inset application

Product Usage Instructions

Planning Information:

The E series oven can be installed in a standard or flush inset application. Ensure a minimum of 6 mm gap between the oven and any cooktop installed above it. Additional cabinet depth may be needed based on the electrical supply location within the oven opening.

Installation Requirements:

For standard installations, ensure that the face trim overlaps stiles and rails as per the provided chart. Properly finish the edges of the opening to ensure a clean look when the door is open.

Base Support:

| Top| Bottom| Sides
---|---|---|---
60 cm OVEN| 6 mm| 0 mm| 17 mm
76 cm OVEN| 25 mm| 0 mm| 18 mm

Electrical Requirements:

Ensure compliance with all applicable electrical codes and proper grounding. A separate circuit dedicated to the oven is necessary. Follow the illustrations for locating the electrical supply. For the 76 cm oven, place the electrical supply flush with the back wall within the specified area.

Electrical Supply:

• Service: 3400 W
• Receptacle: grounding-type (earthed)
• Power Cord Length: 1.8 m

Performance Note:

Avoid compromising performance by ensuring the electrical supply is at least 240 volts. The oven comes with a single phase and 3-phase convertible power inlet box along with a wiring diagram for the control circuit.

Frequently Asked Questions

• Q: Can the E Series Ovens be installed in a standard kitchen cabinet?
  • A: Yes, the E Series Ovens can be installed in a standard or flush inset application within a kitchen cabinet.
• Q: What is the maximum connected load for the 76 cm oven?
  • A: The maximum connected load for the 76 cm oven is 4.8 kW.

E Series Built-In Ovens

The Wolf E Series Convection Oven has two fans and four heating elements. Ten cooking modes allow you to select the one precisely suited to the dish you’re preparing. The oven is self-cleaning. E Series Ovens are crafted of stainless steel. The handles match the rest of the Wolf cooking appliance offering, providing a more cohesive look. E Series Ovens can be installed in a standard or flush inset application.

Features and specifications are subject to change at any time without notice. Throughout this guide, dimensions may vary by ± 3 mm.

60 cm E Series Oven

TRANSITIONAL

TRANSITIONAL

PROFESSIONAL

Planning Information

The E series oven can be installed in a standard or flush inset application. If a cooktop is installed above an oven, a minimum of 6 mm is required between the units. The location of the electrical supply within the oven opening may require additional cabinet depth. Finish the edges of the opening. They may be visible when the door is open. For standard installations, the face trim overlaps stiles and rails. Refer to the chart below. For flush inset installations, a minimum 3 mm reveal is required on all sides. To ensure consistent reveals, each corner of the opening must be exactly 90°.

INSTALLATION REQUIREMENTS

ELECTRICAL REQUIREMENTS—60 cm OVEN

Installation must comply with all applicable electrical codes and be properly grounded (earthed). Locate the electrical supply as shown in the illustrations on the following pages. A separate circuit servicing only this appliance is required.

ELECTRICAL REQUIREMENTS—60 cm OVEN

ELECTRICAL REQUIREMENTS—76 cm OVEN

Installation must comply with all applicable electrical codes and be properly grounded (earthed). Locate the electrical supply flush with the back wall and within the shaded area shown in the illustrations on the following pages. For ease of installation, the electrical supply for the oven can be placed in an adjacent cabinet within reach of the conduit. Performance may be compromised if the electrical supply is less than 240 volts. The oven is supplied with a single phase and 3-phase convertible power inlet box. The wiring diagram covering the control circuit is provided with the oven.

ELECTRICAL REQUIREMENTS—76 cm OVEN

INSTALLATION

60 cm E Series Oven

STANDARD INSTALLATION

NOTE: Location of electrical supply within opening may require additional cabinet depth.

• Will be visible and should be finished to match the cabinetry.
• Dimension provides minimum reveals.

NOTE: The location of electrical supply within opening may require additional cabinet depth.

76 cm E Series Oven

STANDARD INSTALLATION

NOTE: Location of electrical supply within opening may require additional cabinet depth.

76 cm E Series Oven

FLUSH INSET INSTALLATION

• Shaded areas will be visible and should be finished to match cabinetry.
• Dimension provides minimum reveals.

NOTE: The location of electrical supply within opening may require additional cabinet depth.

Warranty

Wolf Appliance International Limited Warranty

FOR RESIDENTIAL USE

These Warranty Terms and Conditions (‘Warranty’) constitute your agreement with Sub-Zero Group Australia Pty Ltd (ACN 610 807 899) (‘Wolf’) and will apply to your service order. The benefits given by this Warranty are in addition to all consumer guarantees and other rights and remedies prescribed by the Australian Consumer Law and any other applicable laws. Our products come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. In addition to your rights and remedies under the Australian Consumer Law, Wolf provides customers with a Warranty where, if any part of a Wolf product is found upon inspection by an authorised Wolf representative or an associated licensed technician supplied by either Wolf or a relevant approved supplier (including a Wolf factory certified service) (‘Service Representative’) to be defective in materials or workmanship, Wolf will repair and replace the part as follows: FULL TWO YEAR WARRANTY* (**Outdoor product full one year warranty) For two years from the date of original installation, this Wolf Appliance product warranty covers all parts and labour to repair or replace, under normal residential use, any part of the product that proves to be defective in materials or workmanship. All service provided by Wolf Appliance under the above warranty must be performed by Wolf factory certified service, unless otherwise specified by Wolf Appliance, Inc. Where the Service Representative is unable to identify any fault in the product, Wolf may require the consumer to provide proof that the product is defective. For the avoidance of doubt, defective products or parts become Wolf’s property. Service will be provided during normal business hours.

LIMITED FIVE-YEAR WARRANTY

For five years from the date of original installation, Wolf Appliance will repair or replace the following parts that prove to be defective in materials or workmanship: gas burners (excludes appearance), electric heating elements, blower motors (ventilation hoods), electronic control boards, magnetron tubes and induction generators. If the owner uses Wolf factory certified service, the service provider will repair or replace the above listed parts at no cost with the owner paying for all other costs, including labour. If the owner uses a non-certified service, the owner must contact Sub-Zero Group Australia, (using the information below) to receive repaired or replacement parts. Wolf Appliance will not reimburse the owner for parts purchased from non-certified service or other sources.

APPLICABLE TO EACH WARRANTY

The warranty applies only to products installed for normal residential use. This warranty does not cover any parts or labour to correct any defect caused by negligence, accident or improper use, maintenance, installation, service or repair.

CLAIM PROCEDURE

In order to claim the Warranty, you must cease using the product when a fault arises, contact Sub-Zero or authorised Sub-Zero dealer where the product was purchased to report the issue and follow Sub-Zero’s directions regarding what to do next. Sub- Zero’s general contact details are as follows:

Sub-Zero Group Australia

• 11-19 Bank Place
• Melbourne VIC 3000
• Phone: 03 9600 2218 email: serviceAU@subzero.com

EXCLUSIONS

Except to the extent required by law, all consumer guarantees, representations, warranties, terms and conditions in relation to the products (whether implied or otherwise) are hereby excluded to the maximum extent permitted by law. To the fullest extent permitted by law, Wolf excludes all liability for damage or injury to any person, damage to any property and any indirect consequential or other loss or damage.

Warranty

• Stainless steel (doors, panels, handles, product frames and interior surfaces) are covered by a limited 60-day parts and labour warranty for cosmetic defects.
•  Full one year warranty applies to the outdoor product. The product must be approved for outdoor use, designated by model and serial number.

subzero-wolf.com.au

References

• Sub-Zero, Wolf, and Cove | Kitchen Appliances that Inspire

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>