shadow-caster SCM Series SCM-AL Marine RGB LED Lighting Strip Instructions
- June 3, 2024
- shadow-caster
Table of Contents
shadow-caster SCM Series SCM-AL Marine RGB LED Lighting Strip
Thank you for purchasing this full-color LED strip from Shadow-Caster Lighting®. This LED strip is meant to be mounted under gunwale areas of the boat and other indirect areas to provide lighting for the interior areas of your boat. The light strip is completely waterproof and wash-down friendly.
Care and handling
Do not twist or pull the LED strip. It is possible to damage solder
connections where the wire is connected to the strip and individual LEDs.
Installation
The LED strip is terminated with 20 ft. of color-coded wire to easily connect
it with Shadow-Caster’s accent lighting controller (SCMALC TM). It is
recommended that the light be mounted in place with clear RTV silicone.
However, enough mounting straps are included with the strip so that one strap
can be placed every 12 inches. If the LED strip is too long, it can easily be
cut using scissors at 3-inch increments, anywhere there is a cut mark shown
(See Picture).On the strip, locate the 12 volts “12V” Imprint (See ‘A’). Use
scissors to cut the line (See ‘B’) to the left of “12V”. Then use a cap (not
shown) to end the
Shadow-Caster LED Lighting, LLC 1237 Lady Marion Lane, Dunedin, FL 34698 USA Tel 727-474-2877 www.Shadow- Caster.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>