shadow-caster SCM-PD4CH 4 Position Power Control Box Installation Guide
- June 9, 2024
- shadow-caster
Table of Contents
shadow-caster SCM-PD4CH 4 Position Power Control Box Installation Guide
DESCRIPTION
The Shadow-Caster™ 4 Channel Power Distribution module is designed to offer a convenient way to distribute power to 4 underwater lights, and provide individual light over current protection in a convenient IP67 module. Each output channel is rated for 15 amps, and has its own 4 pin DT waterproof connector.
USE
Each channel output 1-4 is current protected at 15 amps. If this load is exceeded, the output channel will turn off, and the channel status indicator light will turn red to indicate a fault condition. To reset, remove the overload condition, and cycle the power switch.
PIN OUTS
| Channel Outputs | Connection |
|---|---|
| Pin 1 | Ground |
| Pin 2 | Yellow – Shadow-NET™ High |
| Pin 3 | Orange – Shadow-NET™ Low |
| Pin 4 | Red +12V out (use) |
| Input Connector | Connection |
| --- | --- |
| Pin 1 | Turn On (input) |
| Pin 2 | Yellow – Shadow-NET™ High |
| Pin 3 | Orange – Shadow-NET™ Low |
| Pin 4 | Power 20mA (output) |
WIRE GAUGE REQUIREMENTS
Sufficient wire gauge is critical. Insufficient gauging can cause voltage drop
which leads to over current conditions. Scan the QR Code or click here to
view our recommended wire gauge chart.
SCHEMATIC
For use in Shadow-NET™ installations:
For use in power toggle control applications:
DIMENSIONS
Designed & Manufactured in Clearwater, FL © 2023 Shadow-Caster ® LEDs. All Right Reserved.
Support
Shadow-Caster® LED Lighting | 2060 Calumet Street | Clearwater, FL 33765
p: +1 727.474.2877
e: info@shadow-caster.com
w: shadow-caster.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>