optic arts LLRGB42-XX LineLED Wet 24V Strip Light Instruction Manual
- June 3, 2024
- optic arts
Table of Contents
LLRGB42-XX LineLED
Wet 24V Strip Light
Instruction Manual
REV0.5
10122022
LLRGB42-XX LineLED Wet 24V Strip Light
Please read all instructions prior to installation and keep for future reference!
- PRODUCT SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN
- ENSURE POWER IS OFF AT FUSE BOX PRIOR TO INSTALLATION TO PREVENT ELECTRICAL SHOCK
- USE ONLY WITH CLASS 2 POWER UNIT
- SUITABLE FOR DAMP LOCATIONS
- FOR UNDER CABINET OR SHELF MOUNT
- CONFORMS TO UL STD 2108. CERTIFIED TO CSA STD NO. 250.0.
ATTENTION: ALWAYS TEST LLRGB42 BEFORE INSTALLING. CONNECT LL42-RGB TO POWER SUPPLY TO ENSURE IT IS WORKING PROPERLY AND NO DAMAGE HAS OCCURRED DURING SHIPPING.
1.1 Clean area thoroughly where tape will be installed.
For rough surface installations, it is recommended to apply a layer of
Aluminum tape or similar material prior to tape application.
2.1 Remove the paper backing from the LLRGB42 and firmly press down making
sure there are no air bubbles that can cause surface irregularities. Do not
remove the adhesive, removing the adhesive may cause arcing of the Line LED
tape.
2.1 If required for installation, cut the LLRGB42 strip between two rows of
solder pads.
Always cut LLRGB42 from end without connector / wire leads.
4.1 Follow RGB controller and receiver instructions for all wiring
connections.
Refer to diagram for needed components.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
Documents / Resources
|
optic arts LLRGB42-XX LineLED Wet 24V Strip
Light
[pdf] Instruction Manual
LLRGB42-XX LineLED Wet 24V Strip Light, LLRGB42-XX, LineLED Wet 24V Strip
Light, 24V Strip Light, Strip Light, Light
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>