optic arts LL-MONO LineLED 24V Light Strip Instruction Manual
- June 4, 2024
- optic arts
Table of Contents
optic arts LL-MONO LineLED 24V Light Strip
Please read complete instruction prior to installation and keep for future reference!
- Models LL-MONO1. Product should be installed by a qualified electrician.
- Prior to installation ensure power is off at fuse box to prevent electrical shock.
- Use only with Class 2 power unit. Utiliser seulement avec Classe 2 unite d’alimentation electrique.
- Suitable for Damp Locations. Convient Aux Emplacements Humides.
- For under-cabinet or shelf mount.
- Conforms to UL STD 2108. Certified to CSA STD C22.2 No.250.0.
-
Attention: Always test LineLED strip before installing. Connect LineLED to power supply to ensure it is working properly and no damage has occured during shipping. Clean the area thoroughly where the LineLED will be installed. Use the included Heat Sink Tape for all installation of LineLED unless its on a Luminii profile or non-painted aluminum to ensure proper heat dissipation. LineLED may not reach it’s rated average life when installed otherwise.
-
Remove the paper backing from the LineLED and firmly press down making sure there are no air bubbles that can cause surface irregularities to the LineLED. Do not remove the adhesive, removing the adhesive may cause arcing of the Line LED tape.
-
If LineLED power feed is done with 72” wire leads, proceed to wiring with power supply. Otherwise, connect the LineLED power feed connector to the LineLED strip by sliding and securing end of LineLED power feed to male or female connector. Secure by placing clip (one is provided) over the connector and secure using the two screws.
NOTE – Provided 3-pin connector in the LineLED power feed can be removed to allow connection to female end of LineLED. See second illustration below .
-
If length of LineLED needs to be adjusted on site, simply cut the LED strip in between solder pads. Always cut from end with no connector/wire leads. Then use field-cut connectors to power or extend cut sections of LineLED.
-
RECOMMENDED LAYOUT FOR MULTIPLE ADJACENT RUNS OF LINELED FED WITH SEPARATE POWER SUPPLIES
Position power supplies either in the middle of two runs or at the opposite ends.
-
Always ensure power to power supply is off! Follow diagrams to connect power feed wires to power supply. Refer to power supply instructions for wiring line voltage side. Connect positive wire (plus sign tag or red wire) to RED low voltage wire from power supply. Also, connect negative wire (no tag or black wire) to PURPLE low voltage wire from power supply.
OR
Connect positive middle wire (plus sign tag) to RED low voltage wire from power supply. Also, connect BOTH negative wires (no tags) to PURPLE low voltage wire from power supply.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
7777 N. Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>