Optic arts LLHE64-XX 24V Line LED Instruction Manual
- June 3, 2024
- optic arts
Table of Contents
Optic arts LLHE64-XX 24V Line LED
Please read all instructions prior to installation and keep for future reference!
- LLHE64-HO MUST BE PAIRED WITH AN APPROVED LUMINII EXTRUSION
- PRODUCT SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN
- ENSURE POWER IS OFF AT FUSE BOX PRIOR TO INSTALLTION TO PREVENT ELECTRICAL SHOCK
- USE ONLY WITH CLASS 2 POWER UNIT
- SUITABLE FOR DAMP LOCATIONS
- FOR UNDER-CABINET OR SHELF MOUNT
- CONFORMS TO UL STD 2108. CERTIFIED TO CSA STD C22.2 NO.250.0
ATTENTION: ALWAYS TEST LINELED OPERATION BEFORE INSTALLATION. CONNECT LINELED TO POWER SUPPLY TO ENSURE IT IS WORKING PROPERLY AND NO DAMAGE HAS OCCURED DURING SHIPPING
INSTALLATION STEPS
-
Clean the area throughly where the LineLED will be installed.
-
Remove the paper backing from the LineLED and firmlypress down making sure there are no air bubbles that can cause surface irregularities. Do not remove the adhesive! Removing the adhesive may cause arcing of the Line LED tape
NOTE – When removing backing & laying LineLED to surface avoid installing with ripples & bending over 90°.
NOTE – Avoid bending near 1” on both side of the soldered joints. -
If length of LineLED needs to be adjusted on site, simply cut the LED strip in between solder pads. Always cut from end with no connector / wire leads
-
RECOMMENDED LAYOUT FOR MULTIPLE ADJACENT RUNS OF LINELED FED WITH SEPARATE POWER SUPPLIES
Position power supplies either in the middle of both runs or at opposite ends .
-
Always ensure power to power supply is off. Follow diagrams to connect power feed wires to power supply. Refer to power supply instructions for wiring line voltage side.
LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
7777 Merrimac Ave Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>