ADEMCO 2C2BHTRAN Remote Control User Manual
- June 3, 2024
- Ademco
Table of Contents
2C2BHTRAN Remote Control
User Manual
Manual of Remote Control Parameter
- Frequency315MHZ
- Work Voltage7∼12V
- Work current14ma±1ma
- Quiescent current: 0uA
- Code: rolling code HCS301
- Work distance: 80m in the open area with Receiver
Learning code(Match the remote with receiver ):
When the receiver connects with power, the LED of the receiver light on. Then
you press the learn button on the receiver, receiver LED starts to flash.
Press the remote control button within the 30s, and the receiver LED flashes
faster and light on, it’s mean matching the receiver and remote successfully.
Note: When you press the remote control, the LED of the remote control will
light on. If you keep pressing, the LED keeps light.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not
cause interference, and (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>