ADEMCO 650MK Flush Mounting Kit Instruction Manual

June 9, 2024
Ademco

650MK Flush Mounting Kit
Instruction Manual

650MK Flush Mounting Kit for Nos. 650,651 Series
Passive infrared Motion Detectors

TEMPLATE

  1. Cut opening in wail by making use of this template. Cut (4) 1” Diameter holes, and then cut top, bottom and sides of round cornered opening.
  2. Insert c;(o. 650MK into opening , with TOP as indicated in diagram.
  3. Insert 4 sprin clips provided into slots in No. 650MK. us se either of the two slots at each corner.
  4. Secure spring clips with screws provided. Insert screws into self-threading holes and tighten inner part of each clip down against its spring tension, thus holding the No. 650MK securely  in place. See Section “A-A”.
  5. Guide conductors into detector and mount detector in No. 650MK as follows: Engage HOOKS at lower edgeof No. 650MK into bottom of detector housing base and secure base to POSTS at upper edge of No. 650MK. Use the two hex head screws provided with thedetector. The WALL PLATE provided with the detector is not needed.

ADEMCO 650MK Flush Mounting Kit - fig

ALARM DEVICE MANUFACTURINO CO.
165 Eileen Way, Syoss&, New York 11791
P9223 8/81
Copyright© 1991 PITTWAY CORPORATION
www.PDF-Zoo.com
firealarmresources.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals