BoomToneDJ BOOMASTER800 Powered Speaker User Manual

BoomToneDJ BOOMASTER800 Powered Speaker

INSTRUCTION

Please read the manual carefully and keep it for future reference.

The lightning flash with arrowhead symbol, within an equilateral Triangle, is intended to alert the user to the presence of not insulated dangerous voltages within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of impor- tant operating and maintenance (servicing) instructions in the literature accompanying the appliance.

CAUTION:

• Do not place any recipients filled with liquids, such as glasses or vases, on top of or directly next to the appliance. They could fall over, causing water to enter the appliance. Never pour out liquids over the appliance. Do not place small objects, such as coins or paper clips, on the appliance since they could fall inside the appliance and cause fire or a shock hazard! If any liquid or objects enter the appliance, pull immediately the mains plug out of the socket and contact a specialist.

• 0nly pull the mains plug out of the socket by the intended gripping surface. Do not pull it by the cable.

• Never plug the mains plug in or out with damp or wet hands

• Electrical appliances must be kept out of the reach of children. Be particularly careful if children are present. Children are not aware of the hazards involved in handing electrical appliances improperly. Children could attempt to poke objects into the appliance. There is a life-threatening danger of electrocution.

• Never place the appliance on an unstable or mobile surface. Persons could be injured or the appliance da- maged by
  it falling down.

• AII persons involved in operating, installing and servicing the appliance and putting it into service must be trained
  and qualified accordingly and observe these operating instructions.

• Defective mains cables may only be replaced by specialists. Danger of shock hazard!

• If you are not sure about the correct connection or if questions arise which are not answered by the operating instructions, please do not hesitate to contact support or a specialist of your choice. Consult a specialist if you are in doubt about the operating principle or the safety of the product.

• Please unplug the adaptor and switch the unit off if you don’t use it for a long time, to avoid damage due to voltage surges.

• No naked flame sources such as lighted candles should be placed on the apparatus.

• A warning that batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.

The device in operation cannot be exposed to extreme temperatures (not below 5 ° C and not above 35 ° C)

The device can only be used indoors Use of the Remote Control

Please operate the remote control within a distance of 6m and 30° between the remote and the appliance. Aim the remote at the sensor. Remove all obstacles between the remote and the sensor. The remote control might not work properly if the sensor is exposed to strong sunshine. If the remote control doesn’t work properly, please check the batteries

RECOMMENDATIONS FOR BATTERIES

This symbol indicates that used batteries should not be disposed of with household waste but deposited in separate collection points for recycling.

ATTENTION

The danger of explosion if the battery is incorrectly placed. Only replace by the same or equivalent type. Keep new and old batteries out of the reach of children. If the battery compartment doesn’t close properly, stop using the product and keep it out of the reach of children. Batteries shall not be exposed to excessive heat such as sunshine, fire or the like. When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.

WARNING

The supplied remote control contains a battery. In case of ingestion, it might cause serious internal burns within only 2 hours that might lead to death. If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact immediately a doctor.

Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local authorities or your dealer about the way to proceed.
In accordance with the requirements of CE standard
Recycled products can be recycled
The product is suitable for indoor use

REMOTE CONTROL

1. Mute: Mute
2. MODE button> Select AUX / USB / TF / BLUETOOTH / FM
3. REC for recording microphones
4. Previous title in USB / TF mode
5. Repeat (single / general repeat) in USB / TF mode
6. Keys 0-9
7. REC play to play the recording
8. Increase the volume
9. Play / pause (sound is muted in pause mode) in USB / TF / BT mode
10. Next title in USB / TF mode
11. Decrease the volume
12. Turn on or off the leds on the speakers

CONTROL PANEL

1. MENU to enter the echo and microphone volume adjustment + turn knob (7) to adjust between 00 and 30
2. Previous button to go back to the previous song (USB) or radio station.
3. Play / Pause button. In radio mode a long press launches a scan of FM radio stations
4. Next button to skip to the next song (USB) or radio station.
5. MODE to switch between the different inputs (Line, Bluetooth, USB, Radio). In BT mode, a long press of 3 sec. Disconnects the Bluetooth connection with the connected device.
6. Priority microphone button. Lower the overall volume when speaking into the microphones
7. MULTI VOL to adjust the echo and volume of the microphones.
8. MASTER VOL General volume control
9. Microphone input 1 on 6.35mm jack
10. Microphone input 2 on 6.35mm jack
11. Line input (Aux) in 3.5mm jack. To connect a tablet, or any other device equipped with a 3.5mm jack audio output
12. TF card input (max 32Gb)
13. 15Volts power input. To connect the supplied 15VDC – 4A power adapter (No other adapter can be connected under penalty of loss of manufacturer’s warranty)
14. USB input (max 32Gb)
15. On / off switch O / I
16. 10KHZ> to adjust the high frequencies (10,000Hz)
17. 1KHZ> to adjust the Medium frequencies (1000Hz)
18. 300HZ> to adjust low-medium frequencies
19. 100Hz> to adjust the bass

CHARGING THE BUILT-IN BATTERY

Before first use, charge the device. To do this, connect the supplied 15V-2A adapter to a 220-240VAC mains socket on one side and to the DC15V input on the speaker (13) A red light will then light up on the screen. When the battery is 100% charged this indicator turns green. You can unplug the adapter and use your speaker.

BLUETOOTH OPERATION

1. Turn on the unit and press the MODE button (5) on the unit or the remote control to select the BLUETOOTH function “BLUE” and the unit will enter search mode.
2. Activate the Bluetooth function on the external device to be synchronized.
3. Start the device search. The loudspeaker is known as “BOOMASTER800”.
4. Select it and enter the password “0000” if necessary.
5. Press the play button on the device on the remote control to start playback.

Select the titles with the NEXT and PREV keys and the Volume with the rotary button, making sure that the volume of the Bluetooth source (mobile, tablet) is active.

TWS MODE

• TWS mode allows you to use 2 BOOMASTER800 speakers in stereo. You need 2 speakers for this.
• Put the 2 speakers in Bluetooth mode. Connect to one of the 2 with the device.
• After the connection is established, press the Play / Pause button twice. The TWS connection will then be established with a specific sound.
• After pairing, one speaker will be the left channel and the other the right channel (Stereo)
• Long pressing the MODE button (5) will cancel the function.

MICROPHONE RECORDING

• In USB / TF reading mode and after inserting a USB key (14):
• Press and hold the REC button on the remote control to start recording microphones to the USB memory stick.
• The current music stops and recording begins when 00:01 is displayed. You can plug in a microphone and record the sound from the microphone. If you plug the USB stick / micro-SD card into this speaker for the first time, the system will create a folder.
• The REC function only records sound from microphones and never sounds from line input or Bluetooth.
• To listen to the recording, press the REC play button on the remote control.

LINE IN MODE

• To use this mode, press the mode button (5) until LINE is displayed on the screen.
• Then connect a compatible device using a mini-jack cable to input (11) and adjust the volume using (8).

USB/TF OPERATION

• Compatible music files: MP3, WMA
• Press the MODE button (5) to switch the audio sources to USB.
  • Play / Pause: Press to play, pause and resume play.
  • Back / next: During playback, press once to go back to the beginning of the current title or the next title.

USING THE RADIO (FM)

• Press the mode button (5) until FM is displayed on the screen.
• Long press the Play / Pause button to search for radio stations. They will be saved automatically.
• Press the or buttons to select the desired station.

USE OF MICROPHONES

Connect the microphone to the microphone input provided (9) and / or (10). Adjust the volume with the MENU button (1) and (7)

Technical Specification

The EU declaration of conformity is available on our website www.msc- distribution.om

Imported by BoomtoneDJ – MSC
9 Avenue Camille Flammarion
91630 Avrainville / FRANCE
infos@msc-distribution.com
Tel : +33 1 69 34 80 62
www.boomtonedj.com

References

• distribution.com
• MSC-Distribution.com
• MSC-Distribution.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>