BoomToneDJ com TRAVELSOUND15-VHF Portable Pa System On Battery with Microphones User Manual

BoomToneDJ com TRAVELSOUND15-VHF Portable Pa System On Battery with

Microphones

CONTROL PANEL

1. LCD screen

2. USB port (plays .wav and .mp3 files)

3. SD card slot

4. Remote control receiver (max angle 30° and max distance 6 meters)

5. MP3 player control
   MODE BUTTON: to change between USB/SD/BT/FM
   BACK BUTTON: to go to the previous song. Long press to decrease player volume Forward BUTTON: To go to the next track. Long press to increase player volume
   Repeat BUTTON: repeat one / repeat all / random / TWS mode (see below)
   Play/Pause BUTTON “ Scan: to play or pause. In FM mode, to start a scan for radio stations.

6. Master volume control

7. Bass control for low frequencies

8. Treble control for high frequencies

9. Microphone volume control

10. Pickup bass control

11. Pickup Treble Control

12. Microphone echo control

13. Microphone delay effect control

14. Line input volume control (21)

15. Guitar volume control (23)

16. Battery charge indicator (charge-full-low)

17. Mic1 XLR input jack

18. Mic1 input jack

19. Microphone priority function

20. Mic 2 input jack

21. XLR line input

22. Line in RCA

23. Guitar Input

24. XLR line out to another speaker with XLR line in

25. Main power switch

26. Charge switch (for charging the battery)

27. Current input AC IN 100-240VAC 50/60Hz

28. 12V external battery interface (for connecting a 12V battery)

HOW TO USE

1. Before first use, fully charge the battery (a 10-hour cycle is recommended).
2. Connect your source to the speaker. (Make sure all devices are turned off when making connections).
3. Turn on your source (CD player, mixer, etc.).
4. Check that all the levels of your speaker are at minimum, then turn on the speaker.
5. Depending on the source connected, gradually raise the corresponding potentiometer as well as the MASTER level (6).
   When you store your speaker, be sure to fully charge the battery before storing it. The battery is guaranteed for 6 months.

TWS MODE

The TWS mode allows the use of 2 TRAVELSOUND15-VHF speakers in stereo bluetooth. You must have 2 identical speakers for this.

1. Put the 2 speakers in Bluetooth mode (5)
2. On one of the 2 speakers, press and hold the TWS button on the MP3 module (5). The both speakers are now paired.
3. Connect via Bluetooth to the speaker.

INSTALLATION

Never install and use this device near a source of humidity: swimming pool or wet ground. Do not expose this equipment to rain and ensure that no object containing a liquid, a vase for example, is placed on the device.
Do not install near a source of heat such as a heater, a hot-air vent, or quite other device loosening of the heat, notably the amplifiers. The speaker can be placed on 35mm tube or speakers stands.

WIRELESS MIC

The TRAVELSOUND15-VHF is equipped with 2 wireless microphones that can be used simultaneously. Use 1.5V AA batteries to power them, then turn the switch to ON. Your microphones are now working. Slightly increase the volume by turning the knob (9). Be careful, too high a setting can weaken the loudspeakers and cause feedback.
Since the product incorporates a VHF signal transmission and reception system, its use is exclusively reserved for professional use. The user of the product assumes full responsibility for his use of the product. The marketer shall in no way be liable for any misuse made by the consumer of the product.

TECHNICAL SPECIFICATIONS

Imported by BoomtoneDJ – MSC  7 avenue du 1er Mai
91120 Palaiseau / FRANCE infos@msc-distribution.com
Tel : +33 1 69 34 80 62
The EU declaration of conformity is available on our website www.msc- distribution.com
www.boomtonedj.com

References

• BoomToneDJ
• distribution.com
• MSC-Distribution.com
• MSC-Distribution.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>