LARSON GAU-12-IPS-LED-UV Black Light Swivel Mount Fixture Installation Guide
- June 3, 2024
- LARSON
Table of Contents
LARSON GAU-12-IPS-LED-UV Black Light Swivel Mount Fixture
INSTALLATION
This light fixture can run on voltages of 12/24 DC.
- Mount fixture in desired location using 1/4” screws (not included).
- To position, loosen the mounts at the ends, adjust fixture to desired angle, and re-tighten to hold in place.
- Run cord and plug into matching receptacle within operating voltage. The field wiring terminations are to be made following acceptable practices as outlined by the NEC/CEC for either the specific ordinary or hazardous locations as dictated by the installation location.
- Energize luminaire and toggle power switch ON to illuminate light.
Features
- 10 Watts
- 12-24 DC
- 50,000+ Hour Life Expectancy
- Voltage: 12V-24V DC
- Beam Type: 100° Flood OR 30° Spot
MAINTENANCE
Caution: To avoid personal injury, disconnect power before performing
maintenance.
Perform visual, mechanical and electrical inspections on a regular basis. We
recommend routine checks to be
made on a yearly basis. Frequency of use and environment should determine
this. It is recommended to
follow an Electrical Preventive Maintenance Program as described in NFPA 70B:
Recommended practice for Electrical Equipment.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR
YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD FURTHER INFORMATION NOT
COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS
BY EMAIL AT SALES@LARSONELECTRONICS.COM OR BY
PHONE AT 1-800-369-6671 FOR FURTHER
ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>