FUJIFILM XF56mmF1.2 R WR Lens Owner’s Manual
- June 3, 2024
- Fujifilm
Table of Contents
FUJINON LENS
XF56mmF1.2 R WR
BL00005148-101
OWNER’S MANUAL
For Your Safety
Be sure to read these notes before use
Safety Notes
Thank you for your purchase of this prod- uct. For repair, inspection, and
internal testing, contact your Fujifi lm dealer.
-
Make sure that you use the lens correctly.
Read these safety notes and the camera Owner’s Manual carefully before use. -
After reading these safety notes, store them in a safe place.
About the Icons
The icons shown below are used in this document to indicate the severity of
the injury or damage that can result if the in- formation indicated by the
icon is ignored and the product is used incorrectly as a result.
WARNING| This icon indicates that death or serious injury canresult if
the information is ignored.
---|---
CAUTION| This icon indicates that personal injury or material damage can
result if the information is ignored.
The icons shown below are used to indi- cate the nature of the instructions which are to be observed.
****| Triangular icons tell you that this information requires attention
(“Im- portant”).
---|---
| Circular icons with a diagonal bar tell you that the action indicated is
prohibited (“Prohibited”).
| Filled circles with an exclamation mark indicate an action that must be
performed (“Required”).
WARNING
Do not use in the bathroom or shower| Do not immerse in or expose to water.
Failure to observe this precaution can cause a fi re or
electric shock.
---|---
| Do not disassemble. Failure to observe this precaution can cause fi re,
electric shock, or injury due to product mal- function.
Do not touch internal parts| Should the case break open as the result of a
fall or other ac- cident, do not touch the exposed
parts. Failure to observe this precaution could result in Do not touch
internal parts electric shock or in injury from touching the damaged parts.
Remove the camera battery immediately, taking care
to avoid injury or electric shock, and take the product to the point of
purchase for consul- tation.
WARNING
| Do not place on unstable sur- faces. The product may fall, causing injury.
| Do not view the sun through the lens or camera viewfi nders. Failure to
observe this precau- tion can cause permanent visual impairment.
CAUTION
| Do not use or store in locations that are exposed to steam, or smoke or are
very humid or
extremely dusty. Failure to observe this precaution can cause fi re or electric
shock
| Do not leave in direct sunlight or in locations subject to very high
temperatures, such as in a closed vehicle on a sunny day. Failure to observe
this precau- tion can cause fi re.
CAUTION
| Keep out of the reach of small children. This product could cause injury in
the hands of a child.
| Do not handle with wet hands. Failure to observe this precau- tion can cause
electric shock
| Keep the sun out of the frame when shooting backlit subjects. Sunlight
focused into the camera when the sun is in or close to the frame can cause fi
re or burns.
| When the product is not in use, replace the lens caps and store out of
direct sunlight. Sunlight
focused by the lens can cause fi re or burns.
| Do not carry the camera or lens while they are attached to a tripod. The
product can fall or strike other objects, caus- ing injury.
For Customers in the U. S. A.
Tested To Comply With FCC Standards FOR HOME OR OFFICE USE FCC
Statement: This device complies with Part 15 of the FCC Rules. Operation is
subject to the follow- ing two conditions:
- This device may not cause harmful interference, and
- this device must ac- cept any interference received, including interfer- ence that may cause undesired operation.
CAUTION: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protec- tion against harmful
interference in a residential in- stallation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communica- tions. However, there is no guarantee that inter- ference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be de- termined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a cir- cuit diff erent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- You are cautioned that any changes or modifi – cations not expressly approved in this manual could void the user’s authority to operate the equipment.
Notes on the Grant: To comply with Part 15 of the FCC Rules, this product
must be used with a Fujifi lm-specifi ed ferrite-core A/V cable, USB cable, and
DC supply cord.
For Customers in Canada
CAN ICES-3 (B)/NMB-3(B)
CAUTION: This Class B digital apparatus complies with Canadian ICES-003.
IMPORTANT SAFETY INSTRUCTIONS
- Read these instructions.
- Keep these instructions.
- Heed all warnings.
- Follow all instructions.
- Do not use this apparatus near water (excluding waterproof products).
- Clean only with a dry cloth.
- Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
- Do not install near any heat sources such as ra- diators, heat registers, stoves, or other apparatus (including amplifi ers) that produce heat.
- Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
- Only use attachments/accessories specifi ed by the manufacturer.
- Unplug this apparatus during lightning storms or when unused for long periods of time.
- Refer all servicing to qualifi ed service personal.
Servicing is required when the apparatus has been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the ap- paratus has been exposed to rain or moisture, does not operate normally, or has been dropped.
Disposal of Electrical and Electronic Equipment in Disposal of Elecal and
ElecPrivate Households Households
In the European Union, Norway, Iceland and Liechtenstein: This symbol on
the product, or in the manual and in the warranty, and/or on its packaging in-
dicates that this product shall not be treated as household waste.
Instead it should be taken to an applicable collection point for the recycling
of electrical and electronic equipment.
By ensuring this product is disposed of correctly, you will help prevent
potential negative conse- quences to the environment and human health, which
could otherwise be caused by inappropriate waste handling of this product.
The recycling of materials will help to conserve nat- ural resources. For more
detailed information about recycling this product, please contact your local
city offi ce, your household waste disposal service or the shop where you
purchased the product.
In Countries Outside the European Union, Norway, Iceland and Liechtenstein: If
you wish to discard this product, including the batteries or accumulators,
please contact your local authorities and ask for the correct way of disposal.
U.K. Importer:
FUJIFILM UK Limited
Fujifi lm House, Whitbread Way, Bedford,
Bedfordshire, MK42 0ZE, United Kingdom
EU Importer:
FUJIFILM Electronic Imaging Europe GmbH
Fujistrasse 1 47533 Kleve, Germany
Before Using This Product
The lens may not perform as expected and some features may not be available
with out- dated lens or camera fi rmware. Be sure to up- date the lens and
camera fi rmware to the latest versions. Instructions on viewing fi rmware
ver- sion information and updating fi rmware are available from the following
website:
https://fujifilm-x.com/support/download/firmware/
If you do not have access to a computer, sup- port is available from the local
distributor listed in the “FUJIFILM Worldwide Network” material provided with
your camera.
Product Care
- When using a lens hood, do not pick up or hold the camera using only the hood.
- Keep the lens signal contacts clean.
- Use a blower to remove dust and lint from the glass surfaces of the lens or fi lter. To remove smudges and fi ngerprints, apply a small amount of lens cleaner to a soft, clean cotton cloth or lens-cleaning tissue and clean from the center outwards using a circular motion, taking care not to leave smears or touch the glass with your fi ngers.
- Never use organic solvents such as paint thinner or benzene to clean the lens.
- Attach the front and rear caps when the lens is not in use.
- Store the lens and fi lter in cool, dry locations to prevent mold and rust. Do not store in direct sunlight or with naphtha or camphor moth balls.
- Keep the lens dry. Rusting can cause irrepara- ble damage. Wipe off rain and water droplets.
- Leaving the lens in extremely hot locations could cause damage or warping.
Parts of the Lens
XF56mmF1.2 R WR
- Lens hood
- Mounting marks
- Focus ring
- Aperture ring lock release
- Mounting marks (focal length)
- Aperture ring
- Lens signal contacts
- Front lens cap
- Rear lens cap
The lens mount includes a rubber ring to ensure that the lens remains dust- and splash-proof. The ring can be re- placed for a fee at any Fujifi lm service center.
Attaching the Lens
See the camera manual for information on attaching and removing lenses.
Q This product is for use exclusively with the FUJIFILM X mount.
It is not compatible with the G mount or with X mount fi lm cameras.
Removing the Caps
Remove the caps as shown.
Attaching the Hood
When attached, lens hoods reduce glare and protect the front lens
element.
Supplied Accessories
- Front lens cap
- Rear lens cap
- Lens hood
- Lens wrapping cloth
The Aperture Ring
Rotate the lens aperture ring to choose the aper- ture (f-number).
- A ): Set aperture to the value chosen auto- matically by the camera.
- Other values ( ): Set aperture to the select-
To select A, or to select another value after selecting A, press the aperture ring lock release while rotating the aperture ring.
Specifi cations
| Type | XF56mmF1.2 R WR |
|---|---|
| Lens construction | 13 elements in 8 groups (2 aspherical elements, 1ED |
element)
Focal length (35 mm format equivalent)| f=56 mm (85 mm)
Angle of view| 28.5°
Max. aperture| f/1.2
Min. aperture| f/16
Aperture control Number of blades Stop size| 11 (rounded diaphragm opening) V3
EV (23 stops)
Minimum focus distance (measured from focal plane)| 0.5 m
Max. magnification| 0.14x
External dimensions: Diameter x Length (approx.) distance from front of
lens to lens mount flange| 079.4 x 76 mm
Weight (approx.) excluding caps and hoods| 445 g
Filter size| 067 MM
Filter size
Improvements may result in unannounced changes to specifi cations and
appearance.
Owing to how this lens is constructed, the “Distance indicator”
displayed by the camera may in some cases diff er from the actual focus dis-
tance. Use the “Distance indicator” as a guide only.
7-3, AKASAKA 9-CHOME, MINATO-KU,
TOKYO
107-0052, JAPAN