WILLIAMS P322016 Millivolt Wall Thermostat Instructions

: September 29, 2024
: williams

Table of Contents

P322016 Millivolt Wall Thermostat
Product Specifications:
Product Usage Instructions:
1. Remove Thermostat Cover:
2. Disconnect Power Source:
3. Locate Thermostat:
4. Install at Proper Height:
5. Wiring Installation:
6. Connect Wires:
7. Avoid Interference:
8. Replace Cover:
- FAQ (Frequently Asked Questions):
Q: What should I do if I am replacing a mercury-containing
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

P322016 Millivolt Wall Thermostat

“`html

Product Specifications:

Product: Thermostat
Installation: Wall-mounted
Power Source: Wired
Placement: Indoor with good air circulation
Operating Height: Approximately 5′ above the floor
Wiring: Must be approved by applicable codes

Product Usage Instructions:

1. Remove Thermostat Cover:

Detach the thermostat cover from the base by squeezing the sides
firmly and lifting, as shown in FIGURE 1.

2. Disconnect Power Source:

If the thermostat is connected to a power source, disconnect it
before proceeding with the installation.

3. Locate Thermostat:

Place the thermostat in an area indoors with good air
circulation, avoiding installation on an outside wall.

4. Install at Proper Height:

Mount the thermostat approximately 5 feet above the floor for
optimal performance.

5. Wiring Installation:

Ensure to use electrical wiring that complies with applicable
codes. Feed the wires through the rectangular slots on the
thermostat’s base as depicted in FIGURE 2.

6. Connect Wires:

Connect the wires to the terminal screws inside the thermostat
according to the wiring diagram provided in FIGURE 3.

7. Avoid Interference:

Make sure that the wiring does not interfere with the
thermostat’s operation once connected.

8. Replace Cover:

After completing the wiring and ensuring proper installation,
securely replace the thermostat cover on the base.

FAQ (Frequently Asked Questions):

Q: What should I do if I am replacing a mercury-containing

device with this thermostat?

A: If replacing a device containing mercury,
ensure proper management of the mercury to comply with state or
federal regulations. The mercury should not be disposed of as part
of solid waste or wastewater. For additional guidance, contact the
manufacturer of the product being removed or reach out to the
Director of Environmental Services.

“`

THERMOSTAT INSTALLATION INSTRUCTIONS
1. Remove thermostat cover from base as shown in FIGURE 1. 2. If the thermostat is connected to a power source, disconnect it. 3. Locate the thermostat in an area with good air circulation
(not on an outside wall). 4. Install the thermostat approximately 5′ above the floor. 5. Use electrical wiring approved by applicable codes. 6. Feed wires through the rectangular slots as shown in FIGURE 2. 7. Connect the wires to the terminal screws as shown in FIGURE 3. 8. Make sure the wiring does not interfere with thermostat’s operation. 9. Replace the cover.

10 15 20 25 30 Cº Off 50 60 70 80 90 Fº
FIGURE 1
(front view) Squeeze sides firmly and lift

FIGURE 2
(back view)

FIGURE 3
(inside view)

WARNING: If this product is used to replace a device containing mercury, the purchaser or consumer
must insure that the mercury is properly managed to comply with state or federal regulations. The mercury must not become part of solid waste or waste water. Additional guidance may be obtained from the manufacturer of the product being removed or by calling the Director of Environmental Services.