Speed Link SL-800012-BK AUDIS Streaming Instruction Manual
- June 15, 2024
- Speed Link
Table of Contents
Speed Link SL-800012-BK AUDIS Streaming
GET STARTED
- Screw the microphone holder onto the tripod.
- Place the condenser microphone into the microphone holder and adjust the angle as desired.
- Screw the pop filter to the threaded part of the pop filter attachment.
- Connect the pop filter attachment to the microphone holder and tighten the screw. Use the locknut to fix the pop filter in place.
- Plug the USB cable into a free USB port on your computer.
Technical support: www.speedlink.com
Safety instructions: www.speedlink.com
WEEE: Do not dispose of the product with household waste. Check your
local waste disposal options and take to a recycling point. Improper
storage/disposal may harm the environment and/or human health. Zeitfracht
Medien declares that the product conforms to the requirements listed under the
‘conformity notice’.
INTENDED USE
This product is intended to be used as a microphone for connecting to a computer/other device and is for indoor home/office use only. It contains no user-serviceable parts. Do not disassemble it and stop using it immediately if damaged. Zeitfracht Medien GmbH accepts no liability whatsoever for any damage to this product or injuries caused due to careless or improper use or for purposes for which it is not intended. Please keep this information for later reference.
SAFETY
IMPORTANT SAFETY INSTRUCTIONS
Please note that the failure to observe these instructions can cause product
damage, explosion, fire and/or electric shocks!
- Only use the devices as indicated in the user guide.
- Do not open or repair them.
- Do not expose the devices to liquids, heat or cold.
- Do not use the devices in a damp environment.
- Clean the device with a dry cloth.
- Keep the devices and all loose parts away from children, pets and unauthorized persons.
- Only use the devices with the appropriate provided accessories/cables.
- Disconnect cables from the devices if they will not be used for a long time. When disconnecting the cables, don’t pull on the cord but on the plug.
- Don’t use the cables in any way other than mentioned in the user guide; don’t bend, cut, extend, knot or step on them.
- Do not insert any foreign objects into the openings of the device.
- If the devices are damaged in any way or get too hot, stop using them immediately.
- Take caution when using devices that emit radio signals if you have a pacemaker or are dependent on other sensitive electronic life aids.
- Safety instructions in further languages: www.speedlink.com.
WARNING SYMBOLS AND MARKINGS
CONFORMITY NOTICE
Operation of the device (the devices) may be affected by strong static,
electrical or high-frequency fields (radio installations, mobile telephones,
microwaves, electrostatic discharges). If this occurs, try increasing the
distance from the devices causing the interference. Conformity notice in
further languages: www.speedlink.com.
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: Modifications to this product will void the user’s authority to
operate this equipment.
CONFORMITY NOTICE IMPORTER/MANUFACTURER
Zeitfracht Medien GmbH
Im Dorf 5 27404 Heeslingen
GERMANY
Phone: (+49) 4287 9244-0
PRODUCT DETAILS
Product no.: SL-800012-BK
Type description: AUDIS Streaming Microphone
THE PRODUCT COMPLIES WITH THE FOLLOWING DIRECTIVES
EMC 2014/30/EU
RoHS 2011/65/EU
For a full declaration of conformity, the latest user guide, FAQ or further
information, please visit www.speedlink.com.
All rights reserved. Speedlink, the Speedlink word mark and the Speedlink swoosh are registered trademarks of Zeitfracht GmbH & Co. KGaA. Windows and the Windows logo are registered trademarks of Microsoft Corporation. macOS is a registered trademark of Apple Inc. The Instagram logo is a registered trademark/service mark of Instagram LLC. The Facebook logo is a registered trademark of Facebook Inc. The TikTok logo is a registered trademark of ByteDance. All trademarks are the property of their respective owner. Technical specifications are subject to change. Information contained herein is subject to change without prior notice. Zeitfracht Medien GmbH shall not be made liable for any errors that may appear. Please keep this information for later reference.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>