legrand IP66 Waterproof Bbox Instructions

Table of Contents

Q: Can I use acetone or tar remover for cleaning?
- A: No, surface cleaning should be done with a soft, slightly damp cloth. Avoid using acetone, tar remover, or trichloroethylene.
Q: What type of cables are recommended for outdoor use?
- A: Outdoor use of unprotected flat PVC insulated cables is NOT recommended. It’s advised to use appropriate outdoor-rated cables for safety.
Q: How do I prevent unwanted tampering with the socket?
- A: The product features a lug with a hole that can accept a padlock for security against unwanted tampering.

IP66 waterproof enclosure. Surface mounting receives the mechanisms of the BS range.

RANGE

Designation	Light grey
1 Gang BS Enclosure IP66	6 846 31
2 Gang BS Enclosure IP66	6 846 32

The unit should be fixed to a rigid flat surface as unevenness could cause damage to the product or affect the operation.
If the Front assembly is fitted to the base, remove the fixing screws & remove the Front assembly from Rear Box.
Drill the required number of fixing holes.
- NOTE The drilling out of the drain hole or removing the rear knock-out will reduce the IP rating of the product.
Mount the Rear Box using No.8 screws in all four positions.
Make cable entry into the Rear Box as required. The fixing holes are slotted to allow some rotational adjustment.
The outdoor use of unprotected flat PVC insulated cable is NOT recommended.
Refit Front Assembly onto Rear Box using captive screws- DO NOT OVERTIGHTEN.
Connect the wires to the correct socket rear terminals.
After wiring the socket, put the socket into the Front Assembly using the screws supplied with the socket (M3.5mm) to complete the installation.
For security to prevent unwanted tampering with the Socket, a lug feature with a 6mm hole is provided to accept a padlock.

DIMENSIONS (mm)

References	A	B	C	D(Max)
684631	113.6	151.8	89	120°
684632	169	151.8	89	120°

Material characteristics
- Lid cover / Lid bottom: PC
- Bottom box: PP
- Self-extinguishing: 850°C / 30s
- Resistance to salt spray: 7 days (168 hrs)
Climate characteristics
- Storage temperatures: -10 to +70
- Operating temperatures: -5 to +50
Mechanical characteristics
- Impact test: IK07
- Protection index: IP66

This product must be installed under the latest edition edition of the IEE Wiring Regulations.
Where conduit is used for cable runs, water consideration MUST be prevented from collecting inside the unit & conduit. Drain holes MUST be drilled out.
If a metal conduit is used, earth continuity across the conduit must be maintained using appropriate connections.
Where outdoor cable runs occur, the outdoor use of unprotected flat PVC insulated cable is NOT recommended.
The enclosure is IP66-rated. To ensure continued safety & proper weatherproof operation, the unit MUST not be left with the cover raised open or the catch left unlocked.
Unused cable entries MUST have Blank Plugs Fitted.
The IP66 rating can only be achieved when the cover is pressed down and fastened firmly. Please ensure the cable passes through the center of the cable outlet and is completely enclosed by the special seal.
Possibility to add a Padlock (not supplied).

CONFORMITY – APPROVALS