MIDLAND MT-B01 Plug and Play Intercom System Installation Guide
- September 26, 2024
- MIDLAND
Table of Contents
Powered by INSTALLATION
CONTENTS
MT-B01 is composed of:
- speakers
- control box
- recharging cable type C
- keypad
- wired microphone
- boom mike
CONTROL BOX
On the rear side of the helmet there’s a slot suitable for placing the control box.
Installation:
- unscrew the 2 screws and remove the cover
- Insert the control box
- Close the cover and screw again.
SPEAKERS
Place both speakers in the deep ear pocket of your helmet (if possible). Place both speakers as much as possible close and centered to your ears.
You can hide the speaker wires under the helmet padding.
Attention: for the best sound clarity it is very important to place the
speakers in correspondance with the centre of your ears and as close as
possible (the speakers must almost touch your ears).
MICROPHONES
If you are using the boom microphone, fi x it on the left side and keep the
sponge as close as possible to your mouth (be sure the white arrow is facing
your mouth).
If you use the wired microphone for full-face helmets, fix it on your helmet in
front of your mouth.
EXTERNAL BUTTON
Place the external button on the left side of your helmet using the 3M adhesive.
CHARGING
You can charge your MT-B01 using any standard USB wall adapter or PC port.
MT-B01 is supplied with a USB-C recharging cable.
Distributed by:
AXXIS Helmets
Calle Zagreb, 2
Pol. Ind. Cabezo Beaza,
30353 Cartagena – Spain.
info@axxis-helmets.com – www.axxis-
helmets.com
Produced or imported by:
MIDLAND EUROPE S.R.L.
Via R. Sevardi 7
42124 Reggio Emilia – Italy.
Documents / Resources
|
MIDLAND MT-B01 Plug and Play Intercom
System
[pdf] Installation Guide
110, 150, MT-B01 Plug and Play Intercom System, MT-B01, Plug and Play Intercom
System, Play Intercom System, Intercom System, System
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>