Whirlpool YWED5010LW Electric Dryer with Moisture Sensor Instruction Manual
- June 12, 2024
- Whirlpool
Table of Contents
YWED5010LW, WED5050LW, YWED5050LW, WED6150PB, YWED6150PB, WED6150PW,
YWED6150PW- Electric
WGD5050LW, WGD6150PW, WGD6150PB – Gas
Dryer with Moisture Sensor
Instruction Manual
DETAILED PLANNING DIMENSIONS
WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS and INSTALLATION INSTRUCTIONS, located in your appliance’s Owner’s Manual, before installing and operating this appliance.
Electrical Requirements
Fuel Type| Electric| Gas
Minimum Circuit Amperage Rating| 30 A| 15 A
Maximum AMP Draw| 26 A| 6 A
Operating Voltage| 120/240 V – AC only| 120 V – AC only
Current Canada Rating| 24 A| N/A
Operating Frequency| 60 Hz
Product Dimensions
| in| mm
A| Height (With leveling legs not extended)| 401∕2| 1028
B| Width| 29| 737
C| Top Height (with min. feet)| 367∕8| 937
D| Depth| 283∕8| 722
E| Top Height (With leveling legs fully extended)| 381∕2| 978
F| Height (With leveling legs fully extended)| 421∕8| 1069
G| Depth with Door Open| 5011∕16| 1288
Product Dimensions
| in| mm
H| Strain Relief from Side (elec)| 153∕4| 400
I| Strain Relief Height (elec) (With leveling legs not extended)| 281∕8| 714
J| Exhaust Duct from Side| 147∕16| 366
K| Power Cord from Side (gas)| 143∕4| 375
L| Power Cord Height (gas)| 323∕8| 822
M| Gas Connection (With leveling legs not extended)| 111∕16| 43
N| Gas Connection from Side| 93∕16| 234
O| Strain Relief Height (elec) (With leveling legs fully extended)| 293∕4| 755
P| Exhaust Duct Height (With leveling legs fully extended)| 611∕16| 170
Q| Gas Connection (With leveling legs fully extended)| 3 5∕16| 84
R| Exhaust Duct Height (With leveling legs not extended)| 51∕16| 128
S| Water Inlet Height (on steam models only)| 321∕8| 816
T| Water Inlet from Side (on steam models only)| 4| 101
| Gas Power Cord Length| 60| 1525
| Power Cord Length (Canadian)| 523∕8| 1330
Spacing for recessed area or closet installation
The dimensions shown are for the recommended spacing allowed.
- Additional spacing should be considered for ease of installation and servicing.
- Additional clearances might be required for wall, door, and floor moldings.
- Additional spacing of 1″ (25 mm) on all sides of the dryer is recommended to reduce noise transfer.
- For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilations openings are acceptable.
- Companion appliance spacing should also be considered.
®/™ ©2023 Whirlpool. All rights reserved. Used under license in Canada.
06/23
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>