CW201 Magnetic Wireless Car Charger

Product Information

Specifications

• Model: XYZ-2000
• Power: 1200W
• Capacity: 1.5 liters
• Material: Stainless steel
• Dimensions: 10″ x 8″ x 12″
• Weight: 5 lbs

Product Usage Instructions

1. Initial Setup

Before first use, wash all removable parts with warm soapy
water. Wipe the base unit with a damp cloth.

2. Filling the Kettle

Open the lid and pour water into the kettle up to the desired
level. Do not exceed the maximum capacity.

3. Power On

Place the kettle on the base, plug in the power cord, and press
the power button to start heating the water.

4. Boiling Water

Wait for the water to boil. The kettle will automatically turn
off once the water reaches boiling point.

5. Pouring and Serving

Once the water is boiled, carefully pour it using the spout into
your cup or teapot for serving.

Frequently Asked Questions (FAQ)

Q: Can I use the kettle to heat other liquids besides

water?

A: It is recommended to only use the kettle for heating water to
avoid damaging the appliance.

Q: How do I clean the kettle?

A: After each use, allow the kettle to cool down, then wash it
with a mixture of vinegar and water to remove any mineral
deposits.

Q: Is it safe to leave the kettle plugged in when not in

use?

A: It is advisable to unplug the kettle when not in use for
safety reasons and to prolong the lifespan of the appliance.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: –Reorient or relocate the receiving antenna. –Increase the separation between the equipment and receiver. –Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. –Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Radiation Exposure Statement This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. The FCC certification of this device refers to RF exposure testing performed in typical operating conditions, where a person is no closer than 20 centimeters from the device surface at all times, except for non-repetitive patterns with transient time intervals in the order of a second. Only in the stated conditions, the device is shown to fully comply with the FCC RF Exposure requirements of KDB 447498.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>