8BitDo NGC Controller Bluetooth Kit Instruction Manual
- September 19, 2024
- 8Bitdo
Table of Contents
8BitDo NGC Controller Bluetooth Kit
Mod Kit for NGC Controller
Please handle it with care. 8BitDo is not liable for any damage incurred
during use.
Description
Instruction Manual
- Press the Start button to turn on the controller.
- Hold the Start button for 3 seconds to turn off the controller.
- Hold the Start button for 8 seconds to force the controller off.
Switch
system requirements: Switch 3.0.0 or above.
Bluetooth Connection
- Ensure the controller is OFF, then press and hold Y+Start for 3 seconds to turn on the controller and enter its pairing mode, the Status LED will blink rapidly. (This is required for the very first time only.)
- Go to Switch’s Controller > Change Grip/Order, and wait for the connection.
- The Status LED will remain solid to indicate a successful connection.
Hot Keys
- START + Down = Home Button
- START + Up = Back Button
Android
system requirements: Android 9.0 or above.
Bluetooth Connection
- Ensure the controller is OFF, then press and hold B+Start for 3 seconds to turn on the controller and enter its pairing mode, the Status LED will blink rapidly. (This is required for the very first time only.)
- Turn on the Bluetooth of your Android device and pair it with [8BitDo NGC Modkit].
- The Status LED will remain solid to indicate a successful connection.
Battery
6 hours of playtime with a 300mAh built-in battery pack, rechargeable with 2 hours of charging time.
Status/LED indicator-
low battery mode ————————> red LED stays solid
red LED blinks ————————> battery fully charged
battery charging ————————> red LED turns off
The controller will automatically shut down if it fails to connect within 1 minute of startup, or if there are no operations within 15 minutes after establishing a connection.
Support
Please visit support.8bitdo.com for further information & additional support.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>