COUGAR GEX1050 80Plus Power Supply User Manual
- September 18, 2024
- Cougar
Table of Contents
COUGAR GEX1050 80Plus Power Supply User Manual
Introduction
Dear customer:
Thank you for choosing a COUGAR® power supply unit. Before the installation
please deaf the manual below carefully If you have any questions, please
contact our customer service:
Warnings and safety notes
Never open the PSU cover. There s potential danger of life due to high voltage inside. The PSU should only be opened by an authorized technician. The manufacture warranty will be void, if the PSU is opened by an unauthorized person,
Do not work on the PSU or the PG a5 long o5 the main foliage connected Switch the I/0 button to position 0″ and disconnect the power plug from the power network,
Protect the PSU against moisture.
The PSU is suitable for operation at 100-240V 47-63Hz.
The ambient temperature should not exceed 50°. Please pay attention to the
power de-rating on all models with a decrease of 1%/°C starting at an ambient
temperature of 25°C. Please ensure that there is sufficient ventilation of the
entire system.
Make sure during the installation of the PSU that the ventilation slots are not covered. Do not clog the ventilation slots of the PSU. Keep your PC away from direct heat sources such as radiators.
When using an extension cord and/or multiple sockets pay attention to the maximum through-connection ability in order to avoid short-circuits.
If you want to clean your PSU, disconnect the power plug from the power network and remove it from the PC case. Before the removal make sure that you are not statically charged, (e.g. through carpets or wool sweaters). Only clean the PSU on the outside, always using dry cloth, never water or detergent.
During the operation of the PSU pay attention to the maximum loads. The single loads and the total loads must not exceed to cross the values shown in output power table. Avoid the use of adaptors, such as 4Pin Molex to 6+2Pin PCI- Express.
Technical details and special features
-
80-PLUS® GOLD CERTIFIED
Up to 92% efficiency power conversion for reducing your electricity bill -
FULLY MODULAR POWER SUPPLY UNIT
Connect only the cables you need for less clutter and better airflow -
HDB FAN POWERED
Hydro Dynamic Bearing fan: Extended durability and lower noise levels -
SUPERIOR FAN CURVE TUNING
Advanced tuning technology for noise minimisation -
FLAWLESS OPERATION AT 40°C
Powerful performance at 40°C ambient temperature -
ULTRA-STABLE VOLTAGE OUTPUTS
DC to DC technology for enhanced voltage stability -
SUPPORT FOR MULTI-GPU TECHNOLOGY
Supports PCI Express 4.0 graphic cards with 6+2pin PCI-E connectors SINGLE +12V DC SOURCE Massive outputs for high power devices -
STRONG SAFEGUARDS: OCP, OPP, OVP, UVP, SCP & OTP
Maximum safety for your key system components
Installation/accessories
Before you begin with the installation, please read the section Warnings and safety notes.” For the arrangement only use the supplied screws since these have the correct thread. You need a screwdriver for the correct arrangement.
The following parts are included within the delivery:
- Screws for the PSU assembly
- Power cord (Please only use the power cord which is included; low-quality cords can damage your PSU and your PC-system.)
- Brief instruction incl. Information about the warranty
- Place the PSU into its designated place within the case and fix it with the supplied screws
- First insert the plugs for the ma inboard supply (20/24 pin, 4 pin and possibly 8 pin-according to ma inboard layout) into the respective slots.
- Connect the disk drives and if necessary the graphics cards to the PSU.
- Close the PC and ensure that the PSU power switch is set to the position “0”.
- Connect the PSU to the power network using the supplied power cord. Using only the power cord provided in the package. Low quality power cord may damage the PSU and PC system!
- Turn on the PSU and then start your PC.
Safety functions
-
OVP (Over voltage protection)
If the voltages increase above a certain tolerance value on the single lines, the PSU automatically switches off. -
SCP (Short-circuit protection)
In the case of a short-circuit this feature prevents damage to the core components of the PSU and its system components. -
OPP (Overload protection)
If the system is oversized and requires more power from the PSU than it can perform, this protection function is activated. -
OCP (Over current protection)
If the current on a single line is higher than indicated, the PSU automatically switches off. -
OTP (Over Temperature Protection)
If the temperature is too high, the PSU automatically switches off. -
UVP (Under Voltage Protection)
If the voltages fall below a certain tolerance value on the single lines, the PSU automatically switches off.
Specifications
-
Operating conditions
Working temperature: +10°C~+40°C
(Please note the de-rating condition in Warnings and safety notes) Storage temperature: -40°C~+70°C
Operating humidity (without condensation water): 20%~85% relative humidity
Storage humidity (without condensation water): 5%~95% relative humidity -
Output Power
Model Name| AC input| DC output
---|---|---
3.3V| 5V| 12V| 12V| 5Vsb| Total
GEX1050 GEX 1050| AC100-240V~ 47-63Hz 13-6A| 20A| 20A| 87.5A| 0.3A| 3A| 1050W
| | 1050W| 3.6W| 15W -
Connectors
Connector| Main| CPU| Peripheral| S-ATA| PCI-E
---|---|---|---|---|---
Pin| 24(20+4) Pin| 8(4+4) Pin| Pin| 4 Pin| Pin| 8(6+2) Pin
GEX1050| 1| 1| 1| 4| 12| 4
Trouble shooting
WARNING: nature vered. minimum ork Never work on the PSU yourself. Even long time after its deactivation, life-threatening voltages can still be present in the PSU. Repairs should only be made by authorized specialists.
Working at power sources can lead to life-threatening injuries. If there is
smoke, cable damage or intrusion of liquids the PSU has to be immediately
disconnected from the power network and must not to be put into operation
anymore afterwards.
Never open the PSU. It contains components, which can show high voltages even
after long periods of deactivation.
Again, repairs should only be done by authorized specialists!
Problem : After the installation of the new PSU the system does not
start.
Possible solutions:
- Check the power code and the power supply of the wall socket and/or multiple socket strip. Also check whether the multiple socket strip can supply the necessary power.
- Check all connections within the PC; maybe not all cables are correctly connected.
- Check the internal cable of the I/O-switch of the PC case to the ma inboard.
- Check the components for possible short-circuits or defects.
Please also check the other components for compatibility. Often ma inboard chip sets are not compatible with all memory and/or graphics card solutions. Contact the manufacturer of the component to get more information.
If your PSU still does not function even though you have checked sources of errors mentioned above, please get in touch with our customer service.
This product is not to be disposed in the regular household waste and must be brought to a collection-point for electrical and electronic devices for recycling. The symbol to the left refers to that and can be found on the product, in the manual or on the packaging. Materials can be recycled according to their description. With the reuse, the recycling or other forms of utilisation of old devices you make an important contribution to the protection of our environment. Please inquire the appropriate location of disposal from your local administration.
Warranty and information of the manufacturer
For further information of the warranty terms, please read the information of “Guarantee Terms and conditions for COUGAR Power Supply Units (PSU) of the GEX-Series”.
Legal notices
This manual was created by COMPUCASE ENTERPRISE CO., LTD. and may not be
completely or partially copied, passed on, distributed or stored without
written consent by COMPUCASE ENTERPRISE CO., LTD.
COUGAR is a registered brand of COMPUCASE ENTERPRISE CO., LTD. Other
product and company names mentioned in this documentation may be brands or
trademarks of their respective owners.
COMPUCASE ENTERPRISE CO., LTD. reserves the right to make changes
concerning the contents of the manual and the technical data of the product
without previous announcement.
Guarantee Terms and conditions for COUGAR Power Supply Units (PSU) of the
GEX Series COUGAR provides a 7-year limited warranty on GEX series against
manufacturing defects in УСТА materials and workmanship.
During this period, defects in material or workmanship will be repaired or
restored with spare parts. To make use of the warranty service, the customer
contact the retailer where the PSU was bought and provide a copy of the
invoice and an error description.
Compucase will only support directly if the retailer is not reachable
repeatedly. – разг заф – снач In the case of direct support by Compucase, the
end user shall be responsible for packing the product properly and will assume
all transportation costs.
Compucase’ s warranty does not cover any of the following:
- Damages due to acts of nature (e.g. Lightning, Water, Fire and so on)
- Accessory or consequential damages that happened by using or not using the PSU нахо
- Damages caused by misuse of the PSU or caused by negligence
- Loss of information or data, software or applications
- Damages caused by opening or modifying the PSU without previous accordance
- Damages caused by using or installing the PSU under conditions outside of the technical specifications which are described in the attached manual
This warranty is valid only for the first end user or consumer and is restricted to the above named period.