electriQ Air Purifier User Manual

USER MANUAL
EAP120HC

Thank you for choosing electrIQ Please read this user manual before using this innovative Air Purifier and keep it safe for future reference. Visit our page www.electrIQ.co.uk  for our entire range of Intelligent Electricals

Safety Instruction

Important

• Carefully read the instructions before operating the unit.

• This appliance is for indoor use only.

• his unit must only be connected to a 220-240V / 50Hz earthed outlet.

•  Installation must be in accordance with the regulations of the country where the unit is used.

•  If you are in any doubt about the suitability of your electrical supply, have it checked and, if necessary, modified by a qualified electrician.

• This air purifier has been tested and is safe to use. However, as with any electrical appliance use it with care.

• Disconnect the air purifier from the socket when changing the filters or cleaning the unit.

• Avoid touching any moving parts of the appliance.

• Never insert fingers, pencils or any other objects through the guard.

• This device is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities. It is also not intended for use by those with a lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.

•  Do not leave children unsupervised with this device.

• Do not clean the unit by spraying it or immersing it in water. Use a damp cloth only.
  Never allow water or vapors to enter the unit.

• Do not clean with strong chemical agents or other abrasive materials.

• Never connect the unit to an electrical outlet using an extension cord. If a power outlet is not available, one should be installed by a qualified electrician.

• Never operate this appliance if the cord or power supply are damaged. Ensure the power cord is not stretched or exposed to sharp objects/edges.

• A damaged power supply should be replaced by the manufacturer. Never extend or attempt to change the power supply lead.

• Any service other than a regular cleaning or filter replacement should be performed by an authorized service representative. Failure to comply could result in a voided warranty.

• Do not use the appliance for any other purposes than its intended use.

• Avoid removing the power cord from the socket whilst the unit is still in operation. This could cause electrical damage.

• Never use the power supply as a switch to start and turn off the air purifier unit. Use the provided ON/OFF switch located on the control panel.

• Always place the unit on a dry and stable surface.

• The use of accessory attachments that have not been approved by the appliance the manufacturer is not recommended, as this may result in fire, cause an electric shock and
  or cause personal injury.

• Ensure hands are fully dried before plugging or unplugging the appliance.

• The appliance should not be installed in the laundry or wet rooms.

Energy Saving and Unit Safety Protection Tips

• Do not cover or restrict the airflow from the outlet or inlet grills.
• For maximum performance and safety, the minimum distance from a wall or objects should be 20cm. Keep away from other electrical appliances.
• Keep the filters clean. Under normal conditions, filters should only need cleaning once every two weeks (approximately). Since the filters remove airborne particles, more frequent cleaning may be necessary, depending on the air quality.EAP120HC provides 5 stages of air purification using professional air filtration and intelligent sterilization technologies. This unit features advanced all-in-one dual photocatalytic HEPA and an activated carbon filter for improved air filtration.

– Primary filters, made of non-woven materials, are used for removing large particles like hair and dust.
– Antibacterial HEPA filter to remove 99.9% of airborne particles of 0.25 micrometers or larger.
– Activated carbon filter removes unpleasant odors and absorbs harmful substances such as formaldehyde and benzenes.
– Photocatalytic filter with molecular sieve adsorption layer removes smaller particles and decompose further the pollutants.
– Plasma Ioniser sterilizes even further and removes mold spores and allergens from the air.
The EAP120HC also features an air quality LED indicator that will help in monitoring the quality of the air.

Applications:
– Personal use in domestic and office space to improve air quality
– Helps smokers to minimize the effects of smoking
– Helps asthma and pollen sufferers
– Great for children’s rooms and small offices
NOTE: This air purifier is not a substitute for proper ventilation, regular vacuum cleaning or for the use of a cooker hood whilst cooking. If the humidity is over 60% Relative  Humidity we recommend using a dehumidifier to reduce the humidity.

Air Purifier Features and Indoor Pollutants

VOC (Volatile Organic Compound) – VOCs come from motor vehicle exhausts, gasoline vapor, pollutants such as formaldehyde, ammonia, and many other common and chemical solvents such as paints and glues, or can be a by-product of mold growth. VOCs cause irritation to the eyes and or nose as well as causing headaches, nausea, and even potential damage to the central nervous system. Pressed wood furniture, newly decorated rooms, paint, and cleaning solvents are common sources of VOCs.
Mold / Fungus – these can affect our respiratory system and cause allergic reactions, like a runny nose, eye and throat irritation, headaches, fatigue, and aggravation of asthma.
Other indoor pollutants include – bacteria, viruses, dust mites, and pollen, etc.
Emissions from electronic office equipment – Many studies, including those from EPA and the University of California Berkley, have reported that emissions from office equipment like computers and printers, including VOCs, ultra-fine particles, and ozone.
These emissions have been proven to have a negative effect on the health of many people which can be reduced by busing an air purifier.
Using HEPA filters, Activated Carbon filters, and Plasma Ionisation – An effective HEPA filter is absolutely necessary to remove particles, even at a microscopic level; it ensures that the particles are not spread. Plasma Ionisers will sterilize the air and reduce bacterial growth.
The antibacterial activated carbon on the EAP120HC is a natural material biosynthesized from the walnut shell, the adsorption area of activated carbon is very large up to 300,000
square meters. The activated carbon filter will absorb unpleasant odors and reduce the VOC content in the air.
The Plasma Ioniser will sterilize the air and reduce bacterial growth.

Operation

1. Unpack the appliance and remove the filter cover:
2. Remove the filter and plastic bag: connect it to the DC socket on the bottom:
3. Load 2 composite filters and close the cover:
4. Remove the plug adapter and How to Use:
5. Connect the plug to an earthed socket:
   |
   ---|---

Press the ON/OFF button to turn the unit on. Press again to turn it off.
Pressing the Ioniser button will activate the ionizer function. Press again to turn it off.
With the unit powered on, press the TIMER button to select the automatic off time. Press repeatedly to select 2, 4 or 8 hours.
With the unit powered off, press the TIMER button to select the automatic start time. Press repeatedly to select 2, 4 or 8 hours.
Alter the fan speed by pressing the SPEED button. Select from Medium or High.
The AIR QUALITY indicator will be illuminated blue if air quality is good.
It will be red if the air quality is poor.
Changing the Filter
Open the filter cover by pressing in the retaining tabs and pulling the cover free. Remove the old filters by simply pulling on the tabs to release then.
Replace the filters with new/clean ones and replace the filter cover.

Diagram of Air Purifier

Composite filter

Diagram of Air Purifier

Care and Maintenance

• Always shut off the unit and unplug from the mains before cleaning or performing any maintenance.
• When the unit is not in use for long periods, it is advisable to remove the plug from the power socket.
• Do not use chemical solvents (such as benzene, alcohol, or gasoline) as they may cause irreversible damage to the unit.

Cleaning the Case

• Only use tepid water and a mild detergent on a soft cloth.
• Do not use bleach or abrasives.
• Do not splash water directly onto the main unit.
• Avoid wetting the power connection port, doing so may cause an electric shock and can lead to the insulation deteriorating or unit rusting.

Cleaning the Filters and Filter Holding Area

•  Hoover the filter gently every 2-3 weeks or more often if used in a dustier environment.
•  Make sure the filter is not damaged during the process and replace if it does become damaged.
• Wipe the filter holding area with a dry cloth if necessary.

Clean the filter Cover and Clean Air Outlet

• Use water and a mild detergent.
•  Do not use bleach or abrasives.
•  Do not spray water inside the unit.
• If the clean air outlet grilles get soiled easily, use a vacuum attachment or soft brush to clean.
• If the filter cover is dirty, hoover it. If it is heavily soiled, wash it with warm
  soapy water and dry thoroughly before reinserting it in the unit.

NOTE: Do no assemble the unit and power it on before all the parts are completely dry. Any other maintenance other than what is described in this user manual must be only performed by the service center.

Technical Specification & Troubleshooting

Technical Specification

AC/DC Adapter 12V , XX Amps

Filters| All in one filter cartridges x 2
Purification Rate| Efficiency| Particle
Size| Life Time
VOC| 99.9%| NA| about 1 year
Odors (tobacco, food, pet smells etc.)| 99.7%| NA| about 1 year
Dust, pollen, allergens, mildew| 97%| NA| about 1 year
Bacteria, Viruses, Germs| 94.9%| NA| about 1 year
PM 2.5| 90%| 50.00025
mm| about 1 year
Size (wxdxh)| 10 6 x 6.7 x 3.3 cm
Multifunctional Filter| HEPA Filter layer
| Efficiency| Particle Size| Life Time
99.9%| 50.0003 mm| about 1 year
Pre-filter and Carbon Activated Filter layer
Material| Active Filter
Absorption
Surface| Life Time
Walnut Shell| 300,000 m2| about 1 year
Catalytic Filter layer

Troubleshooting

rating.
Air quality indicator is always red| Sensors can be influenced by water vapor, fumes, and aerosols. Test the unit in another clean environment.
Abnormal Smells| Check if the filters are clean. Replace filters.
Pollutants not removed and loud noise when running| Check if the filters are clean. Replace filters.

Disposal

Disposal: Do not dispose of this product as unsorted waste. Collection of such waste must be handled separately as special treatment is necessary. Recycling facilities are now available for all customers at which you can deposit your old electrical products. Customers will be able to take any old electrical equipment to participate sites run by their local councils. Please remember that this equipment will be further handled during the recycling process, so please be considerate when depositing your equipment. Please contact the local council for details of your local household waste recycling centers.

ElectrIQ UK SUPPORT
www.ElectrIQ.co.uk/support
Please, for your own convenience, check the troubleshooting guide before calling the service line.
If the unit still fails to operate call: 0871 620
1057 or complete the online form
Office hours: 9 AM – 5 PM Monday to Friday

www.ElectriQ.co.uk
Unit 2, The Nursery
Bristow Lane
South Normanton
Derbyshire, DE55 2FX

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>