LaZER GLIDE Lamps with Integrated Position Light Instruction Manual
- September 17, 2024
- LAZER
Table of Contents
LaZER GLIDE Lamps with Integrated Position Light
MOUNTING INSTRUCTIONS
SIDE MOUNTING
NUMBER PLATE MOUNT
FITTING REGULATIONS
- Lamps with integrated Position lights may need to be positioned according to the above sketch. The legal regulations in individual countries must be observed.
- Please scan the QR code to view all UNECE Certificates.
ELECTRICAL CONNECTION
Please disconnect the vehicle battery before installing or servicing your LED light installation. If in doubt, it is recommended to use the services of a professional installer. It is recommended to use the available corresponding Lazer wiring kit for your product. If utilizing existing (non-Lazer) wiring, make sure to use the appropriate wire gauge and fusing in line with your lights.
SUPERSEAL (2-PIN) | GLIDE WITHOUT POSITION LIGHT
SUPERSEAL (3-PIN) | GLIDE WITH POSITION LIGHT
CANBUS INTEGRATION
- For vehicles where it is not possible to locate a 12V high beam signal, it will be necessary to take the high beam signal from the vehicle’s CAN system. For connection options please visit the Lazer Lamps website, or contact your nearest dealer.
LAMP OPERATING MODE
BOOST MODE
- 100% light output for where local laws and regulations allow.
LOW OUTPUT / E-MARK MODE
Reduced output to avoid glare from large reflective objects (e.g. road signs), and/or for operation compliant with UNECE Regulation 149. To activate this mode, with the lights in Boost Mode, flash the light off and on (< 0.5 secs). To return the light to Boost Mode, repeat the process of flashing the light off and on.
We appreciate your purchase of a Lazer Lamps product and value your feedback. If you would like to leave feedback on your Lazer experience, please head to the relevant product page on our website www.lazerlamps.com.
- T +44 (0) 1992 677374
- E sales@lazerlamps.com
- Lazer Lamps Ltd, Calder House, Central Road Harlow, Essex, CM20 2ST, UK