LAZER Licence Plate Mount Instruction Manual
- June 8, 2024
- LAZER
Table of Contents
LAZER Licence Plate Mount
TOOLS REQUIRED
DIFFICULTY LEVEL
WHAT’S REQUIRED
- Lazer High Performance LED Light(s)
- Wiring Kit
- Licence Plate Mount (NPM03)
- Optional: 1x Lazer CAN interface (if your vehicle has LED headlights and you are unable to find a 12V signal from the highbeam headlight trigger.
INSTRUCTION
PRE-INSTALLATION CHECKS
Ensure battery is disconnected.
FITTING YOUR LAMP
Using the included bolts, nuts and washers or self-tapping screws, secure
the brackets and lamp to the licence plate holder on the vehicle, ensuring you
are lining the centre of the lamp with the centre of the licence plate holder
(if you are mounting a single lamp). Self-tapping screws can be used on
bumpers which are manufactured from a strong engineered material such as PC-
ABS, however, in case of a Polypropylene bumper, it is recommended to use the
supplied nuts, bolts and washers to secure the product.
WIRING UP YOUR LAMP
Connect the Lazer wiring harness as shown below and mount the relay close to
the battery: Test for a 12V signal at the back of the high beam headlight plug
to identify if you will require a CAN Interface or not.
STEP 5 – TEST LIGHT
Ensure the light bar(s) are working correctly before re-assembling vehicle
and re-connecting the battery.
TECHNICAL SUPPORT
aaron@lazerlamps.com
sales@lazerlamps.com
+44 (0)1992 945601
+44 (0)1992 677374
NEED HELP
- 44 (0)1992 677374
- sales@lazerlamps.com
- Lazer Lamps Ltd, Units 1&2 Harlow Mill Business Centre,
- Riverway, Harlow, Essex. CM20 2FD. United Kingdom