DAVINCI NICHI 12-24 Wireless Actuator Module User Guide
- September 16, 2024
- DaVinci
Table of Contents
DAVINCI NICHI 12-24 Wireless Actuator Module
Installation Guide
Connect the device to the system that is inside electrical boxes or junction
boxes. Power the device to proceed with the pairing by pressing the P button.
NB. In the event that the time-out for pairing is runs out, the procedure
for the pairing with the control panel can be carried out again by pressing
again the P button.
Signal Management
The following table indicate the warnings and malfunctions indications.
A malfunction appears if there is no radio communication between the control
panel and the device.
| INDICATION | EVENT |
|---|---|
| Red Led flashing | Device not initialized with control panel |
| Green LED flashing every 3 seconds | Device initialized with control panel with |
relay output off
Orange LED fixed light| Activated output
Technical Specifications
| Device type | Radio relay module |
|---|---|
| Ability to implement | 106actuations |
| Communication protocol | GENIO |
| Operating frequencies | 868.20 Mhz, 868.95 Mhz |
| RF power | 13 dB |
| Modulation | GFSK |
| Radio signal | Range up to 1000 m |
| Power supply | 7-24 Vdc |
| Drive Type | High capacity relay |
| Operation mode | Bistable/impulsive (max 250 seconds) |
| Max switch current | 5A |
| --- | --- |
| Contact state | Na/Nc |
| Installation | Indoor |
| Protection class | IP20 |
| Operating temperatures | From -5°С to +45°С |
| Maximum allowable humidity | Up to 75% |
| Dimensions | 29 x 37 x 23 mm |
| Weight | 40 grams |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>