RODE ME-C Plus Video Microphones User Guide
- September 16, 2024
- Rode
Table of Contents
RODE ME-C Plus Video Microphones
IMPORTANT INFORMATION
-
Slide the included mounting clip over the rear of the VideoMic Me-C+ so that the gap in the clip lines up with the USB-C connector
Note: We recommend using the clip whenever suitable, to provide additional support and security, but certain protective cases may not be compatible with the clip -
Connect the microphone to your phone or tablet and adjust the mounting clip until secure
Note: May not be compatible with older operating systems, be sure to update your device to the latest operating system. -
To reduce the impact of wind noise and plosives, slide the included windshield over the front of the microphone
-
To monitor your audio, connect headphones to the 3.5mm output on the rear of the microphone
-
Download the RØDE Reporter app to record audio and update firmware
North America
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Please note that changes or modifications of this product is not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-003 (B) / NMB-003 (B)
Company Name: RODE LLC
Address: 2745 Raymond Ave, Signal Hill CA
90755, USA
Telephone Number: +1 562 364 7400
USA
SOUTH KOREA
ID: R-R-R72-VMMECPLUS
Company Name: RØDE Microphones
Model: VideoMic ME-C+
Country of Origin: Australia
To prevent possible hearing damage, do not listen at high volume levels for long periods.
PRODUCT VIEW
CUSTOMERS SUPPORT
SCAN FOR MORE INFO
View the user guide to learn more
rode.com
0927-0870-03-01