Wallprotex WX2 Colored Polycarbonate Corner Guards Instruction Manual

: September 13, 2024
: Wallprotex

Table of Contents

Wallprotex WX2 Colored Polycarbonate Corner Guards
MORE INFORMATION
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Wallprotex WX2 Colored Polycarbonate Corner Guards

Corner Guards with Holes and Screws or Nails

STEP 1
Wall surfaces must be clean, dry, and free from dust and grease. Wipe the wall surface with a solvent to ensure all grease, dust, and dirt are removed. Make sure that the cleaning solvent used will not damage the ﬁnish on the wall surface.
STEP 2
Remove the clear protective ﬁlm on the exposed side of the corner guard.
STEP 3
3/4” WING
Place in the desired location and hold the corner guard ﬁrmly. Using factory- supplied nails, hammer the nail through the corner guard into the wall.
1-1/8-3 WING
Place in the desired location and hold the corner guard ﬁrmly. Attach the corner guard by placing the provided self-tapping screws in the pre-drilled counter sunk holes and attach to the wall.

**Corner Guards with Double Sided Tape***

STEP 1
- Wall surfaces must be clean, dry, and free from dust and grease. Wipe the wall surface with a solvent to ensure all grease, dust, and dirt are removed. Make sure that the cleaning solvent used will not damage the ﬁnish on the wall surface.
STEP 2
- Remove the clear protective ﬁlm on the exposed side of the corner guard (clear corner guards only).
- Self-adhesive corner guards are easy to install but will break down in high-traffic areas more quickly than a corner guard that is fastened with holes and screws.
STEP 3
Peel off the backing tape from one wing entirely, then peel back the tape partially on on the second wing. Place the wing with the fully exposed tape to the wall, then remove the remainder of the tape backing from the second wing. Press firmly along the entire length of the corner protector to ensure a good bond.

Cutting Polycarbonate
Due to the tough nature of polycarbonate corner guards, Wallprotex does not recommend cutting the corner guards in the ﬁeld. The corner guard material when cut with a power saw can cause the saw to kick back and injure the operator. For custom lengths call before placing an order and Wallprotex can cut the parts to size in the manufacturing process. If cutting is required, use a hacksaw and be careful.

Storage & Handling
The corner guards are shipped unassembled. Upon receipt, the corner guards should be stored in the horizontal position at room temperature (65 °-75 ° F). This is a ﬁnished product; stored in a protected, clean, and dry area away from direct sunlight.

Cleaning Instructions

STEP 1
For best results, the use of liquid cleaners such as “409,” “Fantastic,” and “Mr. Clean,” etc. are recommended. The use of powder cleansers is not recommended. The use of such cleansers can leave a resithathich is difficult to remove.
STEP 2
Do not use chlorinated or aromatic hydrocarbons, esters, or ketones to clean Wallpro-tex vinyl products. Avoid the use of heavy degreasers, compounds containing surfactants, and abrasive compounds or cleaning devices.

Caution