Whirlpool FFT M22 9X2B UK Heat Pump Tumble Dryer User Manual
- June 3, 2024
- Whirlpool
Table of Contents
Whirlpool FFT M22 9X2B UK Heat Pump Tumble Dryer
TROUBLESHOOTING
Before contacting the Service Centre, refer to the table below. Often the malfunctions are minor and can be solved in few minutes.
Malfunction| P o ss i bl e a u s
e| S o l u tio n
---|---|---
The tumble dryer does not turn on.
| the plug is not inserted into the socket
The plug is faulty.
A power failure occurred.
| | Insert the plug into the socket
Try to plug another alliance into the same socket. Do not use connecting electrical devices to the 5ocket. as adapters or extensions.
Await the reactivation of the power supply. Close the __ door.
The tumble dryer does not start.| The door is open.|
-A time delay for the code start was set –
The button Start/Pause was not pressed.ed to start
the program.
The function Key Lock was enabled (in case of machines equipped with this option).
| For machines equipped with this function: (IW(lit the end of the del(ly tor switch the machine off to re5et it. Refer to the sectiion_.2ptions.
Press the button Start/Pause.
Refer to the option .section and, if the Key Lock is Present, disable it.
Switching the machine off is n ot enough to disable this option.
The drying times are very long.
The program did end.
Program finishes and duties were damper than expected.
| Appropriate maintenance was not carried out.
The program, the time, and/or the drying level set are not suitable for the type and the
…a. mount of load inserted into the dryer.
-The garments are too wet .
| Refer to the section Care & Maintenance and perform the operation described,
Refer to the section program memes and options to find the program and the options mo5t suitable fur the type of load.
Carry out a washing cycle with a higher spin speed to remove a5 much water as possible.
Refer to the program section to check the load for each
program.
The dryer may be overloaded.|
Room temperature.
A power failure occurred might have occurred Small load.
| The drying time may be longer if the room temperature falls ide the 0″C range.
In case of power failure, it is necessary to pres5the button Start/Pause to restart the cycle.
The auto Celtic program lemme is. not sensed the required final moisture and the dryer will complete the program and stop. If tit happens simply select an additional short period of drying or select the extra dry option if available.
Lights on or flashing
Note: some models are self-cleaning and not equipped with a bottom filter. Please refer to the section Care &Maintenance.
**You can download the Safety Instructions, User Manual, Product Fiche
and Energy data by**
- Visiting our website: docs.whirlpool.eu
- Using QR Code
- Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When contacting our After-sales Service, please state the codes provided on your product’s identification plate.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>