STRIP LIGHT GUYS 22AWG Indoor Connector Tail Instructions
- September 11, 2024
- STRIP LIGHT GUYS
Table of Contents
STRIP LIGHT GUYS 22AWG Indoor Connector Tail
Product Specifications
Product| Compatible Series| Width| Voltage Range| Max Load Rating| Additional
Notes
---|---|---|---|---|---
SUPERNOVA INDOOR 12V/24V Connector + Tail| SUPERNOVA 12V / 24V Indoor| 10mm|
DC3-24V| 96W| Used to create a new run; simply insert the strip into the
corresponding terminals and crimp with pliers to pierce PCB
components for a secure finish
Product Usage Instructions
1. Prepare the LED Strip
Peel back the adhesive tape leaving a sufficient amount of bare strip to
insert into the clip. Make sure you peel back the tape and accompanying
adhesive layer leaving this to re-apply once the connection is complete.
2. Align and Insert LED Strip
Align the LED Strip ensuring the polarities match with the feed cable.
Insert the LED Strip into the corresponding terminals ensuring the strip is
fitted correctly so that the copper pads line up with the clip connector
teeth.
3. Crimp the Connection
Crimp down on the teeth prongs with pliers to pierce your LED Strip PCB
leaving the prongs flush with the connector housing. Check the LED Strip is
locked in and the connection is secure. Re-apply the adhesive tape under the
clip connector ready for installation.
Note: Care must be taken when crimping so as not to crack the outer
housing.
Contact Information:
Please direct all inquiries and quote requests to
info@striplightguys.com.au
Disclaimer:
SLG. All prices are subject to change without warning: please check with
your sales representative prior to ordering. While every effort has been made
to ensure the accuracy of the information presented on this sheet, it is
intended as a guide only, SLG will not be bound by or responsible for any
errors or omissions.
FAQ
Q: Can I use this product outdoors?
A: No, this product is designed for indoor use only.
Q: What is the recommended method for securing the connection?
A: Crimping with pliers is recommended for a secure finish.
SPECIFICATIONS
- COMPATIBLE SERIES SUPERNOVA 12V / 24VIndoor
- WIDTH 10mm
- VOLTAGE RANGE DC3-24V
- MAX LOAD RATING 96W
ADDITIONAL NOTES
Used to create a new run; simply insert the strip into the corresponding terminals and crimp with pliers to pierce PCB components for a secure finish
INSTALATION
- Stil bo in sent into tie ta Measure you feel back the top and connection is complete layer leaving this to re-apply once the Align the LED Strip ensures the polarities match with the feed cable.
- Insert the LED Strip into the corresponding terminals ensuring the strip is fitted correctly so that the copper pads line up with the clip connector teeth.
- Crimp down on the teeth prongs with pliers to pierce your LED Strip PCB leaving the prongs flush with the connector housing. Check the LED Strip is locked in and the connection is secure. Re-apply the adhesive tape under the clip connector ready for installation.
Note: Care must be taken when crimping so as not to crack the outer housing.
Please direct all inquiries and quote requests to
info@striplightguys.com.au
Disclaimer: SLG. All prices are subject to change without warning: please
check with your sales representative prior to ordering. While every effort has
been made to ensure the accuracy of the information presented on this sheet,
it is intended as a guide only, SLG will not be bound by or responsible for
any errors or omissions.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>