STRIP LIGHT GUYS 22AWG Indoor Straight Connector Instructions
- September 11, 2024
- STRIP LIGHT GUYS
Table of Contents
STRIP LIGHT GUYS 22AWG Indoor Straight Connector Instructions
These straight connectors are used to connect two strips together; simply insert both strips into the corresponding terminals and crimp with pliers to pierce PCB components for a secure finish.
- COMPATIBLE SERIES SUPERNOVA 12V / 24V Indoor
- WIDTH 10mm
- VOLTAGE RANGE DC3-24V
- MAX LOAD RATING 126W (24V)
- ADDITIONAL NOTES
Assembly Instruction
Peel back the adhesive tape leaving a sufficient amount of bare strip to reach the centre of the dlip. Make sure you peel back the tape and accompanying adhesive layer leaving this to re-apply once the connection is complete.
Align the LED Strip ensuring the polarities match.
Insert the LED Strip into the corresponding terminals ensuring the strip is fitted correctly so that the copper pads line up with the clip connector teeth.
Crimp down on the teeth prongs with pliers to pierce your LED Strip PCB leaving the prongs flush with the connector housing. Check the LED Strips are locked in and the connection is secure. Re-apply the adhesive tape under the clip connector ready for installation.
Note: Care must be taken when crimping so as not to crack the outer housing.
Please direct all enquiries and quote requests to info@striplightguys.com.au
Disclaimer: SLG. All prices are subject to change without warning: please check with your sales representative prior to ordering. While every effort has been made to ensure the accuracy of the information presented on this sheet, it is intended as a guide only. SLG will not be bound by or responsible for any errors or omissions.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>