LIAN LI EG1300 The Power For Dual Chamber Cases User Manual
- September 11, 2024
- LIAN LI
Table of Contents
LIAN LI EG1300 The Power For Dual Chamber Cases
Power supply installation instructions:
- Turn off the main power of the computer.
- Remove the cables connected to the power supply with the device. (ATX 24P / CPU / SATA / PCIE / IDE).
- Unplug all connectors on the power supply.
- Unscrew and remove the original power supply.
- Mount the new power supply into the chassis.
- Screw EDGE to the case.
- Connect the cables of the power supply to the system and components. (ATX 24P / CPU/ SATA/ PCIE/IDE).
WARNING: The connector is only suitable for one direction. If you cannot insert it smoothly, please try to insert it with the other end.
Package Contents
- EDGE power supply.
- AC power cord.
- DC modular cable set.
- User Manual.
- DC modular cable storage bag.
Contents
Cable comb installation
AC INPUT RATING
WARNING: The original output module cables are only suitable for the corresponding power supply, please do not mix it with other wattages.
Warranty Policy
Thank you for purchasing the LIAN LI product!
LIAN LI ensures that the material and workmanship of this product are
flawless, the warranty period is 10 years, and its effectiveness starts from
the date of purchase. Please keep the relevant receipts and documents as a
basis.
The warranty is applied to damages caused through normal use and is void if it
is resulted from, but not limited to, the following. situations:
- Wear and tear associated with normal use.
- Any modification, abuse, accident, disassembly, misapplication, or unauthorized repair.
- Removal of any manufacturer label(s) or stickers).
- Any improper operation, including any use not under any supplied product instructions.
- Connection to any improper voltage supply.
- Any other cause which does not relate to a product defect in materials or workmanship.
- Damage caused by utilizing any third-party cable for the PSU will result in a waiver of warranty.
USB-Installation
USB-USB Installation
Pass the cable through to the motherboard chamber to connect it to the motherboard’s USB 2.0 header.
USB-Type A Installation
Pass the cable through to the rear of the motherboard to
Connect all kinds of controlle
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>