better bathrooms BBEXPBT Brushed Brass Exposed Bath Waste Installation Guide
- September 11, 2024
- Better Bathrooms
Table of Contents
better bathrooms BBEXPBT Brushed Brass Exposed Bath Waste
Installation instruction
- Connect trap to the bath waste, ensuring the washer is in place.
- Cut the outlet bend to the required length (for wall or floor outlet).
- Slide the free nut onto the outlet bend, flanged side first.
- Place the washer & rubber seal onto the outlet pipe.
- Tighten the free nut onto the trap.
- Fit the flange over the short end of the outlet bend.
- Check for leaks.
- Push the flange against floor or wall.
Diagram Description
The diagram illustrates the installation process with the following steps:
- Step 1: Connect the trap to the bath waste.
- Step 2: Cut the outlet bend to the required length.
- Step 3-5: Slide the free nut onto the outlet bend, place the washer and rubber seal, and tighten the free nut onto the trap.
- Step 6: Fit the flange over the short end of the outlet bend.
The diagram also includes measurements:
- Total length: 597 mm
- Diameter of the outlet bend: 38 mm
- Height of the outlet bend: 244 mm
- Diameter of the flange: 76 mm
- Diameter of the multi-fit connector: 37.5 mm
Contents
- Exposed Cast P Trap
- Outlet Bend
- Flange
- Multi-Fit Connector
Specifications
| Part | Description |
|---|---|
| Exposed Cast P Trap | Used to connect to the bath waste |
| Outlet Bend | Cut to the required length for wall or floor outlet |
| Flange | Fits over the short end of the outlet bend |
| Multi-Fit Connector | Connects different pipe sizes |
FAQ
What tools are needed for installation?
Basic plumbing tools such as a wrench and pipe cutter are needed.
Can the outlet bend be used for both wall and floor outlets?
Yes the outlet bend can be cut to the required length for either wall or floor outlets.
How do I ensure there are no leaks?
Ensure all washers and rubber seals are properly placed and all nuts are tightly secured. Check for leaks after installation.
What should I do if the flange does not fit properly?
Ensure the outlet bend is cut to the correct length and the flange is fitted over the short end of the outlet bend.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>