ENDON 97611 Lorenzo Wall By Massive Lighting Instructions
- June 3, 2024
- ENDON
Table of Contents
Lorenzo Wall By Massive Lighting
Instructions
Safety Warnings
These instructions are for your safety. Please read through them thoroughly
before use and retain them for future reference. If you are in any doubt about
installing this product, consult a qualified electrician.
This product is only suitable for connection to a 220-240V~ 50Hz supply in
accordance with current IEE wiring regulations, and should be installed in
accordance with local uilding regulations. It is for indoor use only, and is
not suitable for a bathroom location.
This fitting is a Class II, Double Insulated product and does not require an
Earth. Live or Neutral must not be connected to Earth.
IMPORTANT: Always switch off the mains supply during installation or
maintenance. We recommend that the fuse is withdrawn or the circuit breaker
switched off at the istribution board whilst work is in progress (turning
off the light switch is not sufficient). Connection should be via a wall
switch to enable safe isolation.
The product must be securely fixed to the mounting surface using the screws
and wall plugs supplied. The screws and wall plugs supplied are suitable for
“masonry” only. Other fixings are not supplied and must be purchased.
Decide on the position of the light fitting or remove existing light fitting.
Note the position of the electrical connections, and ensure there is a solid
mounting surface, referably a wooden joist or joist bridge, to support the
weight of the light fitting.
Take care not to drill into any pipes or mains cables beneath the surface
during mounting holes preparation. Never put anything on the product or hang
anything on any part f this product.
IMPORTANT: Ensure that all electrical connections are tight and that no
loose strands are left out of the terminal.
Never fit bulbs of a higher wattage than those specified on the label (as
these may cause over heating and damage the fitting).
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or
local store for recycling advice.
Care and maintenance
For bulb replacement, switch off the product (preferably, isolate it at the
distribution board) and allow it to cool down (Caution: bulb gets hot during
use).
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this
product.
Troubleshooting
When the bulb does not light after installation:
Ensure there is no electricity failure.
Ensure all the connections are secure.
If you have any doubt about installation/use of this product, consult a qualified electrician.
Assembly Instructions
Scan QR code for multi-language:
UK Manufacturer: BH17 7BY
EU Manufacturer: 1 Gnarrenburg, 27442
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>