ENDON Interiors 1900 Asquith 1 Light Floor Lamp User Manual
- June 3, 2024
- ENDON
Table of Contents
ENDON Interiors 1900 Asquith 1 Light Floor Lamp User Manual
Safety Warnings
These instructions are for your safety. Please read through them thoroughly
before use and retain them for future reference. If you are in any doubt about
installing this product, consult a qualified electrician.
This product is only suitable for connection to a 220-240V~ 50Hz supply. It is
for indoor use only, and not suitable for a bathroom location.
This is a Class l product and must be Earthed. The terminal blocks are
supplied according to requirements of the fitting
Do not attempt to plug in or use this product until it has been fully
assembled. Disconnect from mains during assembly or maintenance. this product
must be used on a stable, flat surface.
Under no circumstances must this floor lamp be covered with any material as
this could pose a safety hazard.
This product is not suitable for persons under 14 years of age.
If the external flexible cable or cord of this luminaire is damaged, it must
only be replaced by a qualified electrician to avoid any electrical hazards.
The lamp must be protected by a 3 amp fuse in the mains plug.
Never put anything on the product or hang anything on any part of this
product.
This product may contain delicate parts – be careful during handling and
maintenance to avoid breakage.
Never fit bulbs of a higher wattage than those specified on the label as these
may damage the fitting.
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or local store for recycling advice.
Care and maintenance
For bulb replacement, switch off the product (preferably, isolate it at the
distribution board) and allow it to cool down (Caution: bulb gets hot during
use).
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this
product.
Troubleshooting
When the bulb does not light after installation:
- Please plug in and operate the switch to turn your lamp on.
- Please check the bulb.
- Please check the 3 amp fuse in the plug and ultimately check the relevant fuse in your fuse box.
If you have any doubt about installation/use of this product, consult a qualified electrician.
Assembly Instructions
Product images may vary. Shade/Bulb be ordered separately.
-
The floor lamp is heavy. Take care during adjustment or maintenance.
-
Remove the shade retaining ring and place the shade carrier over the bulb holder.
Secure with the shade retaining ring. (If your shade has an integrated carrier you can attach the shade directly in a similar manner.) Place your shade onto the shade carrier. -
Install light bulb of the correct wattage.
-
Plug the lamp into a wall socket, taking care not to put any unnecessary strain on the cable and ensuring the cable does not cause a trip hazard.
Scan QR code for multi-Language
UK Manufacturer: BH17 7BY
EU Manufacturer:
Brilliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>