09CC-HH-MB Ceiling Cassette

“`html

Product Information

Specifications

• Models Covered: ACiQ-09CC-HH-MB, ACiQ-12CC-HH-MB,
  ACiQ-18CC-HH-MB, ACiQ-24CC-HH-MB, ACiQ-36CC-HH-MB,
  ACiQ-48CC-HH-MB

• UV-C Lamp: Included

• Dimensions: 980mm x 975mm x 410mm (38.58in x 38.39in x
  16.14in)

• Weight Range: 180-200kgf.cm to 85-110 N.m (850-1100kgf.cm)

Product Usage Instructions

UV-C Lamp Safety Instructions

– Do not operate UV-C lamps outside of the appliance.
– Do not use damaged appliances.
– Disconnect power before conducting user maintenance.
– Do not attempt to clean, repair, or replace the UV-C lamp.
– Do not remove UV-C barriers bearing the ULTRAVIOLET RADIATION
hazard symbol.
– Avoid staring at the UV emitter light source.

Connecting Pipe Installation

– Hang the intake grille on the panel.
– Connect the lead connectors of the louver motor and control box
to the main body connectors.
– Install cover rope Panel hook.
– Reinstall the installation cover and fix it in place.
– Slide the four slide fasteners into corresponding slots on the
panel.

Breezeless Function Activation

– For models with the feature, dip switch SW2-2 should be ON to
activate breezeless function under cool mode.

Disclaimer

The design and specifications of the product are subject to
change without prior notice for product improvement. Check with the
sales agency or manufacturer for details. Updates to the manual
will be available on the service website.

For any further queries or assistance, please refer to the FAQ

section below.

FAQ

Q: Can the UV-C lamp be replaced?

A: No, the UV-C lamp cannot be cleaned, repaired, or replaced
according to safety guidelines.

Q: How do I activate the breezeless function?

A: For models with this feature, turn dip switch SW2-2 ON to
enable breezeless mode under cool setting.

“`

CEILING CASSETTE
INSTALLATION & OWNER’S MANUAL
Models Covered: ACiQ-09CC-HH-MB ACiQ-12CC-HH-MB ACiQ-18CC-HH-MB ACiQ-24CC-HH- MB ACiQ-36CC-HH-MB ACiQ-48CC-HH-MB

w
IMPORTANT NOTE: Read this manual carefully before installing or operating your new air conditioning system. Make sure to save this manual for future reference.

VERSION DATE: 08-16-24

UV-C lamp(Applicable to the unit contains an UV-C lamp only)
This appliance contains a UV-C lamp. Read the maintenance instructions before opening the appliance. 1. Do not operate UV-C lamps outside of the appliance. 2. Appliances that are obviously damaged must not be operated. 3. Unintended use of the appliance or damage to the housing may result in the escape of dangerous UV-C
radiation. UV-C radiation may, even in small doses, cause harm to the eyes and skin.

4. Before opening doors and access panels bearing the ULTRAVIOLET RADIATION hazard symbol for the conducting USER MAINTENANCE, it is recommended to disconnect the power.
5. The UV-C lamp can not be cleaned, repaired and replaced. 6. UV-C BARRIERS bearing the ULTRAVIOLET RADIATION hazard symbol should not be removed.
WARNING This appliance contains an UV emitter. Do not stare at the light source.

Connecting pipe

980X975X410(38.58X38.39X16.14) 980X975X415(38.58X38.39X16.34)

616(24.25) 616(24.25)

397(15.6) 397(15.6)

(180-200kgf.cm)
32-39 N.m (320-390kgf.cm)
49-59 N.m (490-590kgf.cm)
57-71 N.m (570-710kgf.cm)
67-101 N.m (670-1010kgf.cm)
85-110 N.m (850-1100kgf.cm)

Hang the intake grille on the panel, and then connect the lead connectors of the louver motor and the control box on the panel to the corresponding connectors of the main body.
Install cover rop Panel hoo
Re-installed into the style grid. Reinstall the installation cover. Fix the installation cover plate rope to the pillar of the installation cover plate, and gently press the installation cover plate into the panel.
When installing the cover, slide the four slide fasteners into the corresponding slots on the panel. NOTE: After installation, the electrical connectors of display, swing, water pump and other wire bodies must be placed in the electric control box.
Page 47

Breezeless function of dip switch. NTOE: This feature is only available under cool mode.
This feature is for some models.
INDOOR UNIT MAIN BOARD

SW2-1

SW2-2

SW2-2 dip switch to be “ON”,turn on the breezeless.

SW2-2 dip switch to be “OFF”,turn off the breezeless.

The design and specifications are subject to change without prior notice for product improvement. Consult with the sales agency or manufacturer for details. Any updates to the manual will be uploaded to the service website, please check for the latest version.
QS002UI-Q4 16123000A31700

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>