TORRAS 2AN4Y-PB12 Power Bank User Manual
- September 6, 2024
- TORRAS
Table of Contents
2AN4Y-PB12 Power Bank
Product Specifications:
- Model: PB12
- Product Code: 09-10-11-12
- Dimensions: 5in x 3in x 2in
- Weight: 1lb
- Material: Plastic
Product Usage Instructions:
1. Initial Setup
Before using the PB12, ensure it is fully charged by connecting
it to a power source using the provided cable.
2. Powering On/Off
To power on the PB12, press and hold the power button for 3
seconds. To power off, repeat the same process.
3. Functionality
The PB12 has multiple functions indicated by the numbers on the
device. Refer to the user manual for specific functions
corresponding to each number.
4. Maintenance
Keep the PB12 clean and dry to ensure optimal performance. Avoid
exposing it to extreme temperatures or moisture.
Frequently Asked Questions (FAQ):
Q: How do I reset the PB12?
A: To reset the PB12, locate the reset button near the charging
port and press it using a small pin or paperclip.
Q: Can the PB12 be used while charging?
A: Yes, you can use the PB12 while it is charging. However, it
is recommended to avoid this for prolonged periods to prevent
overheating.
PB12
09
10
11
12
PB12
01
02
13
14
03
04
15
16
21
22
33
34
23
24
35
36
25
26
27
28
FCC Warning 15.19 Labeling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 15.21 Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 15.105 Information to the user. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. FCC RF Radiation Exposure Statement: 1.This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 2.This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment.
05
06
17
18
07
08
PB12
19
20
29
30
31
32
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>