strands Firefly One Driving Light Instructions
- September 5, 2024
- Strands
Table of Contents
strands Firefly One Driving Light Instructions
RED = +VDC
BLACK = – TO CHASSIS GROUND
WHITE = WHITE POSITION LIGHT
YELLOW = AMBER POSITION LIGHT
GREEN = WARNING LIGHT (BY DAY MODE)
BLUE = WARNING LIGHT (BY NIGHT MODE)
*If you connect the blue wire to the green wire, it will activate night mode. If you remove the connection(blue wire), it will revert to day mode.
READ THIS BEFORE INSTALLATION
READ ALL INSTRUCTIONS AND STUDY DIAGRAMS BEFORE INSTALLING YOUR NEW LIGHTS!
LEGAL MOUNTING
Check with state or local authorities for laws governing usage and proper mounting of your new lights.
TAKE CARE OF YOUR PRODUCT
Keep the product clean. Dirt on the lens and heat-sink may shorten the
products lifetime.
We recommend using lukewarm water and alkaline degreasing. Follow the
degreasing instructions carefully and rinse off gently with cold or lukewarm
water on low pressure.
WARNING!
Strong chemicals should not be used on the product. If you accidently get
strong chemicals on the product, rinse off immediately, use plenty of water so
that no chemicals remain in any joint. Some chemicals have a small amount of
solvent in them, this can dissolve sealing adhesives and compromise the
product’s waterproofness. Some chemicals pull out liquid from plastic and
rubber-based components, which makes the plastic or rubber brittle and bursts
more easily. Be careful not to use high water pressure close up on the
product. If you use high water pressure at short distances, most products find
it difficult to close out the water.
INSTALLATION
If there is a contact/connector on the product, it should not be catted. If the connector is cut, the warranty is not valid.
If the product has loose cable and no connector. If the cable is shorter than 50 cm, the cable must not be catted. If the cable is cut, the warranty is not valid. If the cable is longer than 50 cm, it is ok to shorten the cable, but not shorter than 50 cm. If the cable is cut shorter than 50 cm, the warranty is not valid.
Tighten screws and bolts so that they do not loosen or chafe. Do not tighten screws so hard that the protective bearings on the product breaks.
WARNING!
Do not use higher volts than the product description states. This light
becomes hot under continuous use. Don´t remove or touch the casing for at
least 30 minutes after turning the lamp off.
Contact us if you need support: support@strands.se or +46(0)320-450450
www.strands.se
www.strandseurope.com
References
- Proffs på Fordonsbelysning & Lastbilstillbehör - Strands
- Proffs på Fordonsbelysning & Lastbilstillbehör - Strands
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>