SENCOR SEP 570 BT Wireless Earpods With a Microphone User Manual
- September 5, 2024
- SENCOR
Table of Contents
**SENCOR SEP 570 BT Wireless Earpods With a Microphone User Manual
**
Supply content
“L” and “R” earphone
Charging case
Users manual
USB-C charging cable
SEP 570 BT Bluetooth earphones description
- Charging case
- LED indicator of the left earphone being charged
- Charging case information indicator – battery level value is displayed in %
- LED indicator of the ight earphone being charged
- USB-C charging connector
- Earphone contacts for recharging from the charging case
- Microphone.
- Earphone LED indicator
- Touch pad for earphones control
[ R ] Right earphone storage spaceflight earphone
[ L ]Left earphone storage space, left earphone
Left and right earphone function
2x short touch during an incoming call – answer the call
1x long touch (3 seconds) during an incoming call – call rejection
2x short touch during an ongoing call – end call
2x short touch – play function
2x short touch – pause function
1x long touch – launch SIRI/Google assistant
4x short touch – change GAME / MUSIC mode
Left earphone
1x short touch in music mode – volume down
3x short touch – previous track
Right earphone
1x short touch in music mode – volume up
3x short touch – next track
Putting into operation
Before first use, be sure to read the safety instructions contained in this
user’s manual carefully. Before using the earphones for the first time, remove
the protective film from the charging contacts on the bottom of the earphones
and return them to the charging case. Start charging the charging case and the
earphones to the maximum level.
Opening and closing the case – the case is opened and closed by fli-
pping the top lid from front to back. The picture shows an open case.
Turning on the earphones -Taking the earphones out of the case will
automatically switch them on. When the earphones are in the off state outside
the charging case. Press and hold the touch pad on each earphone and wait for
the earphones to switch on.
Turning off the earphones – Inserting the earphones into the char- ging
case will automatically turn off the earphones. Long press and hold the touch
pad of the earphones until the earphones turn off.
Pairing the earphones with each other – The earphones are already paired
from the factory and do not need to be paired with each other. (If pairing to
TWS mode fails, return the earphones to the charging case and repeat the above
instructions).
Warning: To prevent damage to your hearing, always keep the volu- me
level of your device to a minimum before connecting BT head- phanes to your
mobile device. Keep the touch pad clean and avoid touching other objects or
body parts such as hair. Note: If the BT earphones are not paired with any
device, they will turn off when left idle for a long time. Put them in the
case.
Pairing your earphones via Bluetooth
To pair the BT headphones with your mobile device, do the following: Remove
the earphones from the charging case and search for the Bluetooth earphones
name “SEP 570BT” on the device you want to pair and start the pairing
process. If you are requested to enter a pairing code while your device and
the BT headphones are pairing, use the following code: “0000”. To cancel
the pairing process, disconnect the BT earphones from your mobile device
(cancel the Bluetooth pairing).
Note: To ensure a stable Bluetooth connection, make sure that the
distance between the BT headphones and your paired device is kept within 10
meters. Depending on ambient Interference, in some cases it may be necessary
to maintain a shorter distance between the BT headphones and the paired
device.
Charging
A charged battery provides power for several hours of operation at normal volume levels. A high volume consumes more battery power; therefore, we recommend listening at normal volume levels. When the BT earphones are placed in the charging case, the case LEDs show the charging status of the BT earphones and the char- ging case:
a. The LED indicator of the left “2” and right “4” earphone being char-
ged shows the increasing status – the earphones are being charged b. The LED
indicator of the left “2” or right “4” earphone being char- ged is lit the
earphone charging complete
c. Left “2” and right “4” LED indicator is not lit earphones are char-
ged
d. Charging case information indicator “3” – at 5%, the value flashes to
indicate a low battery.
e. Charging case information indicator “3” – the charging process is
shown by a gradually increasing value from 0% to 100%.
f. Earphone LED indicator “8” slow intermittent LED indication the
earphone is ready for pairing.
g. Earphone LED indicator “8” – continuous LED indication inser- ted
earphones in the charging case show the recharging process.
Attention: For charging, use only the original accessories supplied with
the appliance. To achieve maximum battery life, it is advisable to start
charging the battery only when the battery is low (10%-20%). Charge
continuously until fully charged. If the battery life is already very short,
it is exhausted and we recommend you contact an autho- rised service centre
for more information. Recommendation: If your headphones are not to be
used for an ex- tended period of time, we recommend to fully charge the
batteries once every two to three months.
We recommend to store the BT earphones and the charging case with the battery
charged to prevent irreparable damage to the battery (loss of capacity).
Specification:
- Bluetooth Version 5.3
- Maximum Transmitter Power 100 mW @ 2.4GHz-2.4835GHz
- Codes: SBC, AAC
Safety Notice:
Please observe the rules of the Country or Region which you are in while driving. Do not disassemble or modify the headset at any reason, otherwise, It may damage or burn the headset. If there is any quality problem, please send headset to authorized service center for repairing. Please keep the equipment along with all the accessories out of the reach of children and pets. Extreme temperatures will cause the device deformation, reduce the charging capacity and shorten the working life. Please do not immerse the earphone into water. Guarantee will be lost if damage is caused by immersed into water. It will damage your hearing if you listen with high volume for a long time. It is recommended that only use the lowest volume which is necessary for speaking and listening to music.
Instructions and information regarding the disposal of used packaging materials
Dispose of packaging material at a public waste disposal site.
Disposal of used electrical and electronic appliances
The meaning of the symbol on the product, its accessory or packaging indicates
that this product shall not be treated as household waste. Please, dispose of
this product at your applicable collection point for the recycling of
electrical & electro- nic equipment waste. Alternatively in some states of the
European Union or other European states you may return your products to your
local retailer when buying an equivalent new product. The correct disposal of
this product will help save valuable natural resources and help in preventing
the potential negative im pact on the envi- ronment and human health, which
could be caused as a result of improper liquidati- on of waste. Please ask
your local authorities or the nearest waste collection centre for further
details. The improper disposal of this type of waste may fall subject to
national regulations for fines.
For business entities in the European Union
If you wish to dispose of an electrical or electronic device, request the necessary information from your seller or supplier.
Disposal in other countries outside the European Union
If you wish to dispose of this product, request the necessary information
about the correct disposal method from local government departments or from
your seller.
This appliance complies with EU rules and regulations regarding
electromagnetic and electrical safety. Changes to the text, design and
technical specifications may occur without prior notice and we reserve the
right to make these changes.
Hereby, FAST ČR, a.s. declares that the radio equipment type SEP 570 BT is in
com- pliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address: www.sencor.eu
Manufacturer:
FAST CR, a.s. U Sanitasu 1621
25101 Ricany Czech Republic
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>