SENCOR SEP 550 BT Wireless Ear Pods With A Microphone User Manual
- September 6, 2024
- SENCOR
Table of Contents
SEP 550 BT
USER‘S MANUAL Wireless earpods with a microphone
1. Supply content
“L” and “R” earphone
Charging case
User’s manual
USB-C charging cable
2. SEP 550 BT Bluetooth earphones description
[1] “L” left earphone charging compartment
[2] “R” right earphone charging compartment
[3] Charging case
[4] Charging case battery level display and earphones charging indicator
[5] USB-C charging connector
[6] Earphone LED indicator
[7] Touch pad
[R] Right earphone
[L] Left earphone
Left and right earphone function
Long touch (5 seconds) — turn off/on the earphone
1 x long touch (2 seconds) during an incoming call — call rejection
1 x short touch during an incoming call — answer the call
1 x short touch during an ongoing call — end call
1 x short touch — play function
1 x short touch — pause function
3 x short touch — launch SIRI/Google assistant
Left earphone
Long touch in music mode — reduce volume by one level
2 x short touch — previous track
Right earphone
Long touch in music mode — increase volume by one level
2 x short touch — next track
3. Putting into operation
Before first use, be sure to read the safety instructions contained in this
user’s manual carefully.
Before first use, remove the shipping foil from the contacts of the ear-phones
and place them in the charging case. Wait until the charging case and
earphones are fully charged.
Turning on the earphones — Taking the earphones out of the charging case
will automatically switch them on. When the earphones are in the off state
outside the charging case, press and hold the touch pad on each earphone until
the earphones turn on.
Turning off the earphones — Inserting the earphones into the char-ging
case will automatically turn off the earphones. Long press and hold the touch
pad to turn off the earphones.
Pairing the earphones with each other — The earphones are already paired
from the factory and do not need to be paired with each other. (If pairing to
TWS mode fails, return the earphones to the charging case and repeat the above
instructions)
Caution: To prevent damage to your hearing, always keep the volume level
of your device to a minimum before connecting BT ear-phones to your mobile
device. Keep the touch pad clean and avoid touching other objects or body
parts such as hair.
Note: If the BT earphones are not paired with any device, they will turn
off when left idle for a long time. Put them in the case.
4. Pairing your earphones via Bluetooth
To pair the BT earphones with your mobile device, do the following: Remove the
earphones from the charging case (blue and red intermittent earphone
indication) and look for the Bluetooth earphone name “SEP 550BT” in the device
you want to pair and start the pairing process. Always perform the pairing
process when both earphones are removed from the charging case. If you are
requested to enter a pairing code while your device and the BT earphones are
pairing, use the following code: “0000”.
To cancel the pairing process, disconnect the BT earphones from your mobile
device (cancel the Bluetooth pairing).
Note: To ensure a stable Bluetooth connection, make sure that the distance
between the BT earphones and your paired device is kept within 10 meters.
Depending on ambient interference, in some cases it may be necessary to
maintain a shorter distance between the BT earphones and the paired device.
5. Charging
A charged battery provides power for several hours of operation at normal
volume levels. A high volume consumes more battery power; therefore, we
recommend listening at normal volume levels.
When the BT earphones are placed in the charging case, the led indicators
show:
a. The red continuous earphones indication (on the earphone) indicates
charging.
b. When the USB-C charging cable is connected, the charging case will
indicate the charging status by intermittently displaying the charging status
of the charging case. A fully charged charging case will display 100 on the
level display.
Attention: For charging, use only the original accessories supplied with
the appliance. Always check that the connector of the charging cable fits
snugly into the connector of the charging case. To achieve maximum battery
life, it is advisable to start charging the battery only when the battery is
low (10% — 20%). Charge continuously until fully charged.
Recommendation: If your earphones are not to be used for an ex-tended
period of time, we recommend to fully charge the batteries once every two to
three months. We recommend to store the BT earphones and the charging case
with the battery charged to prevent irreparable damage to the battery (loss of
capacity).
Specification:
• Bluetooth version: Bluetooth 5.3
• Transmission range:15 m
• Charging time: 1 hour
• Number of charges from the charging case: 3 times
• Music playback time: Approximately 5 hours at 60% volume
• Battery capacity: 3.7V 25mAh each earphone, 3.7V 200mAh charging case
• Controls: Touch controls
• Impedance: 16Ω ± 10%
• Driver: ∅ 6 mm x 2x
• Frequency: 20 Hz — 20 kHz
• Sensitivity: 102 ±3 dB
• Material: ABS
• Charging connector: USB-C
Safety Notice:
Please observe the rules of the Country or Region which you are in while
driving.
Do not disassemble or modify the headset at any reason, otherwise, It may
damage or burn the headset.
If there is any quality problem, please send headset to authorized service
center for repairing.
Please keep the equipment along with all the accessories out of the reach of
children and pets.
Extreme temperatures will cause the device deformation, reduce the charging
capacity and shorten the working life.
Please do not immerse the earphone into water. Guarantee will be lost if
damage is caused by immersed into water.
It will damage your hearing if you listen with high volume for a long time. It
is recommended that only use the lowest volume which is necessary for speaking
and listening to music.
Instructions and information regarding the disposal of used packaging
materials
Dispose of packaging material at a public waste disposal site.
Disposal of used electrical and electronic appliances
The meaning of the symbol on the product, its accessory or packaging indicates
that this product shall not be treated as household waste. Please, dispose of
this product at your applicable collection point for the recycling of
electrical & electronic equipment waste. Alternatively in some states of the
European Union or other European states you may return your products to your
local retailer when buying an equivalent new product. The correct disposal of
this product will help save valuable natural resources and help in preventing
the potential negative impact on the environment and human health, which could
be caused as a result of improper liquidation of waste. Please ask your local
authorities or the nearest waste collection centre for further details. The
improper disposal of this type of waste may fall subject to national
regulations for fines.
For business entities in the European Union
If you wish to dispose of an electrical or electronic device, request the
necessary information from your seller or supplier.
Disposal in other countries outside the European Union
If you wish to dispose of this product, request the necessary information
about the correct disposal method from local government departments or from
your seller.
This appliance complies with EU rules and regulations regarding electromagnetic and electrical safety. Changes to the text, design and technical specifications may occur without prior notice and we reserve the right to make these changes.
Hereby, FAST OR, a.s. declares that the radio equipment type SEP 550 BT is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address: www.sencor.eu
Copyright © 2023, Fast t R, a.s. Revision 05/2023
Manufacturer: FAST CR, a.s.
U Sanitasu 1621
25101 Ricany
Czech Republic