PREMIUM LEVELLA PCRN357DR, PCRN427DR Countertop Refrigerator Display Case User Manual

PREMIUM LEVELLA PCRN357DR, PCRN427DR Countertop Refrigerator Display Case

USER MANUAL

Model: PCRN357DR; PCRN427DR

Use and care manual. Important safeguards. This product is for domestic use only.

Thank you for choosing and purchasing our product.

Please carefully read the operating instructions before installing and using the appliance.

General Information

1. A top brand fully enclosed compressor is used on the desktop refrigerator. The refrigerant used, R290, is an environmentally friendly agent.
It features a rational configuration of refrigeration system with forced air cooling. The temperature is even inside the refrigerator.
2. Double hollow transparent glasses are used on door and body. It features an elegant appearance, perfect visibility, and easy access.
3. This refrigerator has wide applications in commercial locations and stores.

Parts of the refrigerator

Handling and Installation

Handle with care
Unplug the wall socket first. Never tilt it over 45 degrees during handling.| Dry place
Always install the refrigerator in a dry place.
---|---
Sufficient space
The distance from both sides and back of the refrigerator to the wall or other surfaces must be at least 10cm. The refrigeration capability might be decreased if its surrounding space is too small to allow air circulation.| Ventilation
Always install the refrigerator at a place with good ventilation. When installing the refrigerator for the first time, wait for 2 hours after handling it, then plug the wall socket and start it.
Far from heat source
Never place the refrigerator directly under the sun. Never install it near any heat source or heater to prevent a negative effect on the refrigeration capability.| No heavy load
Never put any heavy load on top of the refrigerator.
No perforations
Never puncture the refrigerator. Never install any other appliance or materials on top of the refrigerator.| Stable location
To avoid any unexpected noise and vibration, unpack, and install the refrigerator on a flat and solid surface.

Preparation and Power Supply

Exclusive power socket
The power supply should be 110-120V, 60Hz single phase AC, with access to an exclusive single phase three pin wall receptacle.| Do not share a socket!
Never let the refrigerator share a common socket with any other appliance. The cable may become hot and cause a fire.
---|---
Protect cables
Never break or damage the cable. A damaged cable may cause current leakage and fire.| Do not wash with water
Never wash the refrigerator surface with running water. Doing so may cause current leakage or electrocution.
Keep away flammable and explosive materials
Never place any flammable or explosive materials inside the refrigerator, as ether, gasoline, alcohol, adhesives or explosives. Never put dangerous products n ear the refrigerator.| No sprays
Do not use or store flammable sprays as paint or coatings near or inside the refrigerator, at they may cause a fire.
After a power interruption After a power interruption or unplugging the refrigerator, always wail at least 5 minutes before plugging the appliance or starting it again.

| No medicine
Do not keep any medicines inside the refrigerator.

Use and Caution

1. Before use:

Plug the refrigerator in a 110-120V~ exclusive socket.
After the refrigerator is running, put your hand on the air outlet to verify if it is cold enough. Then you may put food inside the refrigerator.

2. Digital Temperature controller

The digital temperature controller is an integrated intelligent controller that controls the one HP compressor.
Its main functions are: Temperature Display/ Temperature Control/ Manual, automatic defrost / Illumination Control/ Value Storing/ Parameter Locking

Front Panel Operation

1. To set temperature:

Press the “Set” button, the set temperature is displayed.
Press the or button to modify and store the displayed value. Press the “Set” button to exit the adjustment mode and display the cold-room temperature.

2. If no other button is pressed within 10 seconds, the cold-room temperature will be displayed.
3. Illumination: Press the  **button, it lights; Press it again, and it stops.
Manual start/stop defrosting:** Press the button and hold it for 6. seconds to start defrosting or stop defrosting.
4. The indicator light twinkles when the compressor stops working and the indicator light is on when the compressor is working.
5. Defrost LED: during defrosting, the LED is on; When it stops defrosting, the LED is off, During the delay display of defrosting, the LED flashes. 6 Digital controller reset: When the display shows “Disorder”, press the ” ” button for 2 seconds until the buzzer rings, quickly press the ” ” button for 6 seconds until the buzzer rings again, the display will flash for 3 seconds, and the factory setting will be restored.

3. Cautions

Keep the door opening times short and reduce the openings frequency to keep the cold temperature inside the refrigerator.
Never block the air suction and outlet to keep good air circulation and refrigeration capability.
Do not overfill the refrigerator, as it will impact its cooling capabilities. Adjust the rack height for proper food storage.
Cool hot food down to room temperature before you put it into the refrigerator.
Try to reduce the opening times to keep the refrigerator inside cold in case the power is cut off.
Only professional technicians are allowed to repair any damaged power cable with special tools.
Never touch the compressor to avoid burns.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons to avoid a hazard. This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Do not store explosive substances such as aerosol cans with flammable propellant in this appliance.
During normal operation, the emission noise level does not exceed 70dB(A).
The maximum loading of the shelf must not exceed 18 kg.
The climatic class of the appliance is 4, the units are suggested to be used at 16 C-32 C (60.8″F-89.6″F) ambient temperature.
To avoid damage or other problems, this product cannot be put or s tared with any corrosive food.

Maintenance

1. Notice
This refrigerator must be kept clean and periodical maintenance is necessary.
Always unplug the socket before performing any maintenance.
Never use a damaged plug, or loose socket to prevent electric shock or short circuit.
Never flush the refrigerator. Never use alkali detergent, soap, gasoline, acetone, or brush to clean it.

2. Clean outside
Use a wet soft cloth with neutral detergent (tableware detergent) to clean the outside of the refrigerator and then wipe it with dry soft cloth.

3. Clean inside
Take the rack out and clean it with water.

4. Shut down the refrigerator for a long time
Take all food out and unplug the wall socket.
Clean both inside and outside of the refrigerator thoroughly and open the door to dry.
The glass may break easily. Keep the glass far from children.

5. Lamp replacement in the light box
If the LED is damaged, it must be replaced by the manufacturer, or its service agent.

Troubleshooting

Is there no power?
Unsatisfactory refrigeration| Is it under the sunshine? Is there any heat source nearby?
Is the surrounding ventilation bad? Does the door close well? Was the door open for a long time?
Is the door seal strip deformed or damaged? Is the refrigerator  too full?
Does food block the air suction or outlet?
Regulate the temperature controller.
Much noise| The refrigerator is not level.
The refrigerator is in contact with the wall or other surfaces.
There is a loose part in refrigerator.
Contact local service agent for help if this simple trouble shooting does not solve the problems.

NOTE:

The following are not problems:
The sound of flowing water is heard when the refrigerator is working. It is a normal phenomenon as the coolant is circulating in the system.
In wet season, condensation might be found on the outside of the refrigerator. It is not a problem; it is caused by high humidity. Simply use a dry cloth to wipe it.

Circuit Diagram

Parameters

Specifications

• Model: COUNTERTOP REFRIGERATOR DISPLAY CASE
• Compressor: Fully enclosed top brand compressor
• Refrigerant: R290
• Glass: Double hollow transparent glasses on door and body
• Power Supply: 110-120V, 60Hz single phase AC

Notes
1. The electric circuit diagram and parameters on the product name plate are final ones if they have been changed.
2. The design might be improved without notice.

WARNING : Refrigerant used is R290, please protect against fire

Meaning of crossed out wheeled dustbin:
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities.
Contact your local government for information regarding the collection systems available.
If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater and get into the food chain, damaging your health and well-being.
When replacing old appliances with new ones, the retailer is legally obligated to take back your old appliance for disposal free of charge.

FAQ

Q: Can I wash the refrigerator with water?

A: No, washing the refrigerator surface with water may cause current leakage or electrocution. Use a damp cloth for cleaning.

Q: What type of power supply does the refrigerator require?

A: The refrigerator requires a power supply of 110-120V, 60Hz single phase AC with access to an exclusive single phase three pin wall receptacle.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>