ZAZU V16 Ocean Projector User Manual
- August 29, 2024
- ZAZU
Table of Contents
**ZAZU V16 Ocean Projector User Manual
**
Take the module out of the plush and place 3x AA batteries (not included). Put
the module back into the plush.
Open the Velcro, on the bottom, to operate the buttons.
Only use alkaline batteries, no zinc carbon.
A Switch on the product by pressing the big BUTTON A
B Choose your favourite melodie with SLIDER B.
OFF: No music
- Ocean sound
- Lullabies
- Heartbeat
C Set the preferred volume: high-low, SLIDER C
D Switch the cry sensor ON/OFF, SLIDER D
when the cry sensor is activated, the sleep program will restart from phase 2,
to calm down and settle your baby
Note Cry sensor stays active for 12 hours.
Auto-off: the entire 3 step sleep program will automatically switch OFF after 30 minutes.
3 STEP-SLEEP PROGRAM
Otto/Cody will calm and sooth your baby to sleep with the unique 3 step sleep
program.
The total program takes 30 minutes and will automatically switch off.
STEP 1 Calming your child
Follow the waves and the orange fish swimming around the room, while listening
to soothing ocean sounds.
STEP 2 Getting sleepy
Lower brightness, moving waves and only a few fish swimming around the room.
Music changes to underwater bubbles.
STEP 3 Falling asleep
Calm waves and sleeping fish. No sound.
For the best projection, locate the product within 1 to 2.5 meters from the
walls and ceiling. When batteries lose their power, the projection decreases,
and the product might lose some of the features
WARNING! SAFETY GUIDELINES
-
IMPORTANT! keep for future reference.
-
This ZAZU product is fully compliant with the EU, CA, AU, NZ, USA and CN legislation.
-
Please keep the packaging away from small children.
-
Never allow your child to play with the batteries.
-
This product works with 3x AA 1.5 V batteries (not included).
-
Only use the specified batteries.
-
Remove empty batteries from the product.
-
Batteries should only be placed by adults.
-
Do not mix old and new batteries.
-
Do not mix alkaline, standard (carbon-Zn), or rechargeable Ni MH) batteries.
-
Only use alkaline batteries, no zinc carbon.
-
Non-rechargeable batteries cannot be charged.
-
Batteries should be placed in the correct polarity.
-
Do not short-circuit the power terminal.
-
When not in use please switch the product OFF completely.
-
Do not place inside the cot or too close to the baby.
-
The plush can be washed by hand and air dried, but remove the module beforehand.
-
This light does not get warm.
-
This product is intended for indoor use and is not water resistant.
Please keep dry. For cleaning do not immerse in water, but wipe with a damp cloth. -
Do not try to disassemble the product if it stops working.
Please contact customer service.
ZAZU Limited | Unit 10, English business P
English Close, Hove, East Sussex
BN3 7ET, Great Britain
Manufactured and distributed by ZAZU
PO Box 299 | 3740 AG Baarn
The Netherlands | info@zazu-kids.nl
V16-MANUAL-CODY-OTTO-2024-04
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>