ZAZU 07-000108 Sunset Projector with 3 Steps Sleep Program User Manual

: June 3, 2024
: ZAZU

Table of Contents

ZAZU 07-000108 Sunset Projector with 3 Steps Sleep Program
3 STEP-SLEEP PROGRAM
WARNING! SAFETY GUIDELINES
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ZAZU 07-000108 Sunset Projector with 3 Steps Sleep Program

ZAZU 07-000108 Sunset Projector with 3 Steps Sleep
Program

Take the module out of the plush and place 3x AA batteries (not included). Put the module back into the plush. Open the Velcro, on the bottom, to operate the buttons. Only use alkaline batteries, no zinc carbon.

A Switch on the product by pressing the big BUTTON A
B Choose your favourite melodie with SLIDER B.
OFF: No music
1. African sunset music
2. Lullabies
3. Heartbeat
C Set the preferred volume: high-low, SLIDER C
D Switch the cry sensor ON/OFF, SLIDER D

when the cry sensor is activated, the sleep program will restart from phase 2, to calm down and settle your baby.

Note: Cry sensor stays active for 12 hours.
Auto-off: the entire 3 step sleep program will automatically switch OFF after 30 minutes.

ZAZU 07-000108 Sunset Projector with 3 Steps Sleep Program
1

3 STEP-SLEEP PROGRAM

Tim will calm and sooth your baby to sleep with the unique 3 step sleep program. The total program takes 30 minutes and will automatically switch off.

STEP 1 Calming your child Follow the birds flying around the room, while listening to soothing african sunset music.
STEP 2 Getting sleepy Lower brightness, the sun has set and there are fewer birds. Music changes to more calm african sunset music.
STEP 3 Falling asleep No more movements No sound.

For the best projection, locate the product within 1 to 2.5 meters from the walls and ceiling. When batteries lose their power, the projection decreases, and the product might lose some of the features.

WARNING! SAFETY GUIDELINES

IMPORTANT! keep for future reference.
This ZAZU product is fully compliant with the EU, CA, AU, NZ, USA and CN legislation.
Please keep the packaging away from small children.
Never allow your child to play with the batteries.
This product works with 3x AA 1.5 V batteries (not included).
Only use the specified batteries.
Remove empty batteries from the product.
Batteries should only be placed by adults.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-Zn), or rechargeable Ni MH) batteries.
Only use alkaline batteries, no zinc carbon.
Non-rechargeable batteries cannot be charged.
Batteries should be placed in the correct polarity.
Do not short-circuit the power terminal.
When not in use please switch the product OFF completely.
Do not place inside the cot or too close to the baby.
The plush can be washed by hand and air dried, but remove the module beforehand.
This light does not get warm.
This product is intended for indoor use and is not water resistant. Please keep it dry. For cleaning do not immerse in water, but wipe with a damp cloth.
Do not try to disassemble the product if it stops working. Please contact customer service.