TELESIN 1.3M Selfie Stick Tripod with Remote Control User Guide
- October 27, 2023
- TELESIN
Table of Contents
1.3M Selfie Stick Tripod with Remote Control
User Guide
1.3M Selfie Stick Tripod with Remote Control
1.3M
Selfie Stick Tripod with Remote Control
How to use
- Remote Switch On/Off long press the on/off button for 3s, the remote switches on/off
- When the GoPro is paired and connected, the GoPro will be switched on and off when the remote control is switched on and off
Connection
Select pairing mode
- long press the mode key
**M**for 3s to switch the pairing mode If it is GoPro pairing mode, the indicator light will turn green and flash; if it is phone pairing mode. the indicator light will tum red and flash
Pairing connection
- To remotely control the gopro, open the remote in the gopro camera, and the pairing will be successful automatically, at which time the indicator light will change from fast flashing to slow flashing
- To remotely control a smart phone, open the phone Bluetooth, search for TC-RCSS, click on the pairing connection, and the pairing will be successful, at which time the indicator will change from fast flashing to slow flashing
- If the remote control is not paired with any device within three minutes, the remote control will automatically shut down
Photo/Recording
- In Gopro pairing mode, click the photo button
**0**to start recording/photography; click the photo button**0**again to end recording/photography again. Click the mode switch key**M**, the camera mode switches among the photo / time lapse / video - In the phone pairing mode, click the photo keys 0 to take pictures; click the photo keys 0 again to take pictures again; long press the photo keys 0 for 2s to start recording; long press the photo keys 0 again for 2s to end recording
Charging status is displayed
when charging is in progress, the indicator shows a red light; when charging
is complete. the indicator shows a green light.
Product Parameters
Model: TE-RCSS-003
Brand: TELESIN
Size: 48x32x245mm
Weight: 320g
Packing list: 13m selfie stick, remote control, phone clip, long screw,
data cable
Remote control
Voltage: 3 7V/40mAh 0.148Wh
Input: USB-C: 5V=100mA,0.5W
Max Operating temperature: 0-45°C
Use time: approximately 5H
Charging time: about 1H
Disclaimer
Please read this statement carefully and by using this product you will be
deemed to have acknowledged and accepted it in full. Please check the product
carefully before each use and do not use it if damaged or deformed. By using
this product, you acknowledge and agree that you are fully responsible for
your actions and the possible consequences of using this product.You undertake
to use this product only for legitimate and lawful purposes. You understand
and agree that (“Telesin”) shall not be liable for any misuse, adverse
effects, damages, injuries, penalties or other legal consequences arising
directly or indirectly from the use of this product. The user should follow
the precautions including but not limited to those mentioned herein. To the
extent Telesin reserves the right to interpret and modify this commitment
within the limits of national laws and regulations.
www.telesin.cn
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>