SAMS CAN-1-01, CAN-1-03 Can Am Outlander ATV Backup Light Installation Guide
- August 26, 2024
- SAMS
Table of Contents
SAMS CAN-1-01, CAN-1-03 Can Am Outlander ATV Backup Light
Product Information
Specifications
- Description: Can-Am Outlander Reverse Light Kit
- Included Components: Wiring Harness, Relay, Bracket, Light, Zip Ties
- Quantity: 1 of each component (except for Zip Ties which are 6 in quantity)
FAQ
Q: What should I do if my lights do not turn on after installation?
A: Check all connections and ensure proper wiring. If issues persist, contact support@samsbackuplights.com for assistance.
Can-Am Outlander Reverse Light Kit
Included
-
Wiring Harness
1 -
Relay
1 -
Bracket
1 -
Light
1 -
Zip Ties
6
Required Tools
- 13mm Combination Wrench
- 13mm Socket
- Phillips Screwdriver
- Wire Cutter (trimming zip ties)
Read entire manual before beginning installation process.
Disclaimer: Sam’s Backup Lights is not responsible for any damage due to improper installation.
Installation
-
Step 1: Remove Plastics
Remove seat.
Note: If installing on Outlander Max remove small plastic extension rear of main side panel. -
Step 2: Mount Controller, Relay, & Fuse
- Zip tie controller to OEM wiring harness.
- Insert (Blue) controller signal wire into relay socket.
- Zip tie relays and fuse to rest of wiring harness.
-
Step 3: Connect Diagnostic Connector & Power Leads
- Remove diagnostic connector cover and plug connector into reverse light wiring harness.
- Connect positive lead to positive terminal of battery and negative lead to negative terminal.
-
Step 4: Mount Light
- Attach the light to its bracket. Be sure to slide the bolt through the bracket before attaching to light. Attach light bracket to mounting bracket.
- Remove the two preexisting lower bolts and refasten with light bracket attached.
-
Step 5: Route Power to Light
- Run wire and connector along factory wiring harness back to reverse light, while zip-tying the wire as needed.
- Plug in the reverse light.
-
Step 6: Reinstall Plastics
Factory Can-Am Diagnostic Connector
The Orange wire from Sam’s Controller needs to match the Orange/Green wire on the factory Can-Am diagnostic connector
Operation of Reverse Lights
Our controllers have been programmed with a manual override feature. Back-up lights may be turned on without the vehicle in reverse.
Fully Automatic When Shifted to Reverse
No programming needed
Manual Override Function
Shift the vehicle into neutral.
Press reverse-override button once. The reverse light will turn on and remain
on.
- To turn the light off repeat this procedure.
Note: If the ignition is turned off while the vehicle is in reverse, or the manual override function is enabled, the lights will remain ON until the ECU enters sleep mode (approximately 30 seconds – 2 minutes depending on vehicle and ECU type).
Sam’s Backup Lights
www.samsbackuplights.com
CAN-1-01
CAN-1-03
Can-Am Outlander Reverse Light support@samsbackuplights.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>