FEIT Electric FESLFILREM String Light Remote Controller User Manual
- June 4, 2024
- Feit Electric
Table of Contents
FESLFILREM String Light Remote Controller
User Manual
– Press 4H: 4 hrs on 20 hrs off.
– Press 6H: 6 hrs on 18 hrs off.
– Press 8H: 8 hrs on 16 hrs off.
NOTE: String light will cycle with set hours until it is reset. To reset, disconnect the plug from the power outlet and plug back into a power outlet.
BATTERY WARNING’
Risk of fire, explosion, and burns. Do not disassemble, crush, heat above100°C
/ 212° F or incinerate. REPLACE ONLY WITH one CR2025 battery. DISPOSE OF USED
BATTERY PROMPTLY. KEEP AWAY FROM CHILDREN. DO NOT DISASSEMBLE AND DO NOT
DISPOSE OF IN FIRE. When replacing the battery, ensure the new battery is
installed correctly with regard to polarity (+ and -) as shown on the remote.
CAUTION’
• Dispose of used batteries promptly according to local recycling or waste
regulations. Clean battery contacts and also device contacts prior to
installing the battery. Ensure the battery is installed correctly with regard
to polarity (+ and —). Remove the battery from the remote when not being used
for an extended period of time. Remove used battery promptly. The LEDs in this
strip light are not replaceable.
WARNING:
– WARNING – KEEP BATTERIES OUT OF REACH OF CHILDREN
– Swallowing may lead to serious injury or death in as little as 2 hours, due
to chemical burns and potential perforation of the esophagus.
– If you suspect your child has swallowed or inserted a button battery,
immediately seek urgent medical assistance.
– Examine devices and make sure the battery compartment is correctly secured,
e.g. that the screw or other mechanical fastener is tightened. Do not use if
the compartment is not secure.
– Dispose of the used button battery immediately and safely. A flat battery
can still be dangerous.
This product contains a button battery. If swallowed, it could cause severe injury or death in just 2 hours. Seek medical attention immediately.
IC STATEMENT
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
FCC STATEMENT
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>