Kimberly Clark PROFESSIONAL 09508 Jumbo Roll Toilet Paper Dispenser Installation Guide

Kimberly Clark PROFESSIONAL 09508 Jumbo Roll Toilet Paper Dispenser

Product Codes 09508 White, 09507 Black

Installation

For available spare parts contact your sales representative.
IMPORTANT! For secure mounting, follow these instructions thoroughly. Ensure that the proper mounting hardware is used for the appropriate wall type.

1. Assess wall surface material to determine if screw anchors are required.
2. Mount the dispenser with the bottom edge approximately 15-48” from the floor and 7- 9” from the front edge of the toilet to the centerline of the dispenser. In the presence of a grab bar rail, mount dispenser so that the outlet is no greater than 12” above the bar, or so that the top of the dispenser is no less than 1.5” below the bar.
3. Use 4 mounting screws as a minimum to attach the dispenser to a wall.

Optional Push Button Lock Feature

Dispenser comes with plug in place. To convert to pushbutton operation:

1. Depress the end of the metal lock spring being careful not to overstress it. Remove the plug, if one is installed, by pushing on it from the inside (Figure 1).
2. Remove one of the pushbuttons from back panel of dispenser (Figure 2).
3. Insert pushbutton into hole from inside of dispenser (Figure 3). Insert metal lock spring back in place, lining up notches on it with ones on back panel. Push bottom tab of lock spring up until it snaps into place.

Loading Instructions

EMPTY DISPENSER (Both hubs empty)

1. Open dispenser using provided key or push button (Figure 1).

2. Install new roll on left hub so that paper unrolls in clockwise direction (Figure 2). Allow approximately 3 inches of leading edge of paper to extend below the bottom of the dispenser.

3. Close firmly and ensure the cover latches. (Figure 5).
   DISPENSER WITH PARTIAL ROLL ON LEFT HUB (Right hub empty)

4. When roll diameter becomes small enough to reveal line on back wall of dispenser (Figure 3).

5. Remove partial roll from left hub. Flip roll so that paper unrolls in counter clockwise direction and install on right hub (Figure 3).

6. Rewind leading edge of partial roll to top inside edge of dispensing opening.

7. Install new roll on left hub so that paper unrolls in clockwise direction. Allow approximately 3 inches of leading edge of paper to extend below the bottom of the dispenser (Figure 4).

*AMERICANS WITH DISABILITIES ACT (For use In U.S. only): Title 111 of the Americans with Disabilities Act (“ADA”) governs, in detail, the placement and operation of dispensers. You should ensure that your mounting and use of dispensers complies with that law as well as the regulations issued under that statue. The mounting suggestions in this document may or may not fulfill the obligations of the ADA with respect to your facility.

KIMBERLY-CLARK CORPORATION DISCLAIMS LIABILITY FOR PERSONAL INJURIES OR PROPERTY DAMAGES RESULTING FROM INSTALLATION NOT PERFORMED BY KIMBERLY-CLARK.
®/™Trademarks if Kimberly-Clark Worldwide, Inc. or its affiliates ®KCWW is a Registered Trademark of Kimberly-Clark Tissue Company. ®1998 KCC. All Rights Reserved. Manufactured for: Kimberly-Clark Corporation, Roswell GA 30076.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>