Leap Frog 6189 Phonics Spin and Learn User Guide
- August 22, 2024
- Leap Frog
Table of Contents
Leap Frog 6189 Phonics Spin and Learn
Product Information
Specifications:
- Model: 6189
- Product Name: Get Ready for PhonicsTM Spin & Learn
- Batteries: 3 AA (AM-3/LR6) batteries required
Product Usage Instructions
Battery Removal and Installation:
- Ensure the unit is turned off.
- Locate the battery cover on the back of the unit.
- Use a screwdriver to loosen the screw and open the battery cover.
- Remove old batteries by pulling up on one end of each battery.
- Install 3 new AA batteries following the diagram inside the battery box. Alkaline or fully charged Ni-MH rechargeable batteries are recommended for best performance.
- Replace the battery cover and tighten the screw securely.
Care & Maintenance:
- Keep the unit clean by wiping it with a slightly damp cloth.
- Avoid direct sunlight and keep away from heat sources.
- Remove batteries if not in use for an extended period.
- Avoid dropping the unit on hard surfaces and exposure to moisture or water.
- If the unit stops working, try installing a new set of batteries.
FAQs
-
Q: Where can I find the complete user manual?
A: The full version of the manual is available online through the provided links or by scanning the QR code in the package. -
Q: What type of batteries does the product require?
A: The product requires 3 AA (AM-3/LR6) batteries. Alkaline or fully charged Ni-MH rechargeable batteries are recommended for best performance.
We aim to reduce our environmental impact and have reduced the amount of paper
used for our printed manuals.
The full version of the manual is available online through the following link
or by scanning the QR code.
Read our complete warranty policy online at leapfrog.com/legal
INCLUDED IN THE PACKAGE
- Get Ready for PhonicsTM Spin & Learn
- Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks, removable
tags, cable ties, cords and packaging screws are not part of this toy, and
should be discarded for your child’s safety.
NOTE Please save this Instruction Manual as it contains important
information.
Unlock the Packaging Locks
- Rotate the packaging locks 90 degrees counterclockwise.
- Pull out the packaging locks and discard them.
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
- Make sure the unit is turned Off.
- Locate the battery cover on the back of the unit. Use a screwdriver to loosen the screw and then open the battery cover.
- Remove old batteries by pulling up on one end of each battery.
- Install 3 new AA (AM-3/LR6) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended.)
- Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation. Keep batteries out of reach
of children.
IMPORTANT: BATTERY INFORMATION
- Insert batteries with the correct polarity (+ and -).
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
- Only batteries of the same or equivalent type as recommended are to be used.
- Do not short-circuit the supply terminals.
- Remove batteries during long periods of non-use.
- Remove exhausted batteries from the toy.
- Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES
- Remove rechargeable batteries (if removable) from the toy before charging.
- Rechargeable batteries are only to be charged under adult supervision.
- Do not charge non-rechargeable batteries.
CARE & MAINTENANCE
- Keep the unit clean by wiping it with a slightly damp cloth.
- Keep the unit out of direct sunlight and away from any direct heat sources.
- Remove the batteries if the unit will not be in use for an extended period of time.
- Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.
- If the unit stops working or malfunctions, install a new set of batteries.
FCC STATEMENT
CAUTION
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services Department at
1-800-701-5327 in the U.S. and Canada,
or email support@leapfrog.com. Creating and developing LeapFrog products is
accompanied by a responsibility that we take very seriously. We make every
effort to ensure the accuracy of the information, which forms the value of our
products. However, errors sometimes can occur. It is important for you to know
that we stand behind our products and encourage you to contact us with any
problems and/or suggestions you might have. A service representative will be
happy to help you.
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
- Trade Name: LeapFrog®
- Model: 6189
- Product Name: Get Ready for PhonicsTM Spin & Learn
- Responsible Party: LeapFrog Enterprises, Inc.
- Address: 2200 Powell St., Suite 500 Emeryville, CA 94608
- Website: leapfrog.com
THISDEVICECOMPLIESWITHPART15OFTHEFCCRULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>